Skip to contentSkip to conversation

How to check if systemd is correctly setup

DISCUSSION Elvis Dowson 2 participants 4 messages Dec 8, 2012

lore
Share & tools
lore
#0 lore raw

Hi,
I haven't used systemd before, and I've just built a linux kernel image using the latest yocto poky/master.

The boot process starts as normal, but it just displays "freeing memory (some value)" and I get no console prompt.

Q1: Which config setting or recipe code, controls the inclusion of systemd in the root filesystem?

Q2: How can I check to see if systemd is properly configured for my target (virtex-5-powerpc-405-ml507-softfloat)?

Best regards,

Elvis Dowson

#1 lore raw
Quoted 8 lines · Elvis Dowson

Hi,
I haven't used systemd before, and I've just built a linux kernel image using the latest yocto poky/master.

The boot process starts as normal, but it just displays "freeing memory (some value)" and I get no console prompt.

Q1: Which config setting or recipe code, controls the inclusion of systemd in the root filesystem?

Q2: How can I check to see if systemd is properly configured for my target (virtex-5-powerpc-405-ml507-softfloat)?

First thing, make sure that your kernel has this in the config:
CONFIG_DEVTMPFS=y
CONFIG_DEVTMPFS_MOUNT=y
The latest udev (rev 182) has to have this to work.

Signature · 4 lines
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------
#2 lore raw

Hi Gary,
Thanks for the reply!

Quoted 6 lines · Gary Thomas
Quoted 5 lines · Elvis Dowson

Hi,
I haven't used systemd before, and I've just built a linux kernel image using the latest yocto poky/master.

The boot process starts as normal, but it just displays "freeing memory (some value)" and I get no console prompt.

Quoted 8 lines
Quoted 3 lines

Q1: Which config setting or recipe code, controls the inclusion of systemd in the root filesystem?

Q2: How can I check to see if systemd is properly configured for my target (virtex-5-powerpc-405-ml507-softfloat)?

First thing, make sure that your kernel has this in the config:
CONFIG_DEVTMPFS=y
CONFIG_DEVTMPFS_MOUNT=y
The latest udev (rev 182) has to have this to work.

Yes, my defconfig has the above two configs set.

Which file control if systemd gets pulled into the core-image-minimal recipe?

Where are the systemd configuration files stored?

Best regards,

Elvis Dowson

#3 lore raw

Hi,

Quoted 8 lines · Gary Thomas
Quoted 5 lines

First thing, make sure that your kernel has this in the config:
CONFIG_DEVTMPFS=y
CONFIG_DEVTMPFS_MOUNT=y
The latest udev (rev 182) has to have this to work.

In my kernel boot message,

devtmpfs: mounted
Freeing unused kernel memory : 168k freed
_

I am able to ping to the board from a terminal console on the host, and I get a reply.

However, I don't see a console prompt, even though on my bootargs i have set init=/bin/sh

Best regards,

Elvis Dowson