Skip to contentSkip to conversation

Signal ok but no Channels && add support Compro Videomate e800 (dvt-t part only)

linux-dvb Vladimir Geroy 1 participant 1 message Apr 30, 2009 Media (V4L/DVB)

lore
Share & tools
lore

Vladimir Geroy

author
#0 lore raw

dmesg

[   13.177367] cx23885 driver version 0.0.2 loaded
[   13.177862] ACPI: PCI Interrupt Link [APC8] enabled at IRQ 16
[   13.177873] cx23885 0000:04:00.0: PCI INT A -> Link[APC8] -> GSI 16 (level, low) -> IRQ 16
[   13.178014] CORE cx23885[0]: subsystem: 1858:e800, board: Compro VideoMate E800 [card=18,autodetected]
[   13.373933] cx25840 2-0044: cx25  0-21 found @ 0x88 (cx23885[0])
[   13.378062] cx25840 2-0044: firmware: requesting v4l-cx23885-avcore-01.fw
[   13.387800] HDA Intel 0000:00:09.0: power state changed by ACPI to D0
[   13.388243] ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 22
[   13.388248] HDA Intel 0000:00:09.0: PCI INT A -> Link[AAZA] -> GSI 22 (level, low) -> IRQ 22
[   13.388299] HDA Intel 0000:00:09.0: setting latency timer to 64
[   14.020387] cx25840 2-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes)
[   14.026309] cx23885_dvb_register() allocating 1 frontend(s)
[   14.026313] cx23885[0]: cx23885 based dvb card
[   14.102491] xc2028 1-0061: creating new instance
[   14.102495] xc2028 1-0061: type set to XCeive xc2028/xc3028 tuner
[   14.102501] DVB: registering new adapter (cx23885[0])
[   14.102506] DVB: registering adapter 0 frontend 0 (Zarlink ZL10353 DVB-T)...
[   14.102855] cx23885_dev_checkrevision() Hardware revision = 0xb0
[   14.102863] cx23885[0]/0: found at 0000:04:00.0, rev: 2, irq: 16, latency: 0, mmio: 0xef600000
[   14.102871] cx23885 0000:04:00.0: setting latency timer to 64

w_scan version 20081106
Info: using DVB adapter auto detection.
Found DVB-T frontend. Using adapter /dev/dvb/adapter0/frontend0
-_-_-_-_ Getting frontend capabilities-_-_-_-_
frontend Zarlink ZL10353 DVB-T supports
INVERSION_AUTO
QAM_AUTO
TRANSMISSION_MODE_AUTO
GUARD_INTERVAL_AUTO
HIERARCHY_AUTO
FEC_AUTO
-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_
177500:
184500:
191500:
198500:
205500:
212500:
219500:
226500:
474000:
482000:
490000:
498000:
506000:
514000:
522000:
530000:
538000:
546000:
554000:
562000:
570000:
578000:
586000:
594000:
602000:
610000:
618000:
626000:
634000: signal ok (I999B8C999D999M999T999G999Y999) 642000:
650000: signal ok (I999B8C999D999M999T999G999Y999) 658000:
666000:
674000:
682000:
690000:
698000:
706000:
714000: signal ok (I999B8C999D999M999T999G999Y999) 722000:
730000:
738000:
746000:
754000:
762000:
770000:
778000:
786000:
794000:
802000:
810000:
818000:
826000:
834000:
842000:
850000:
858000:
tune to: :634000:I999B8C999D999M999T999G999Y999:T:27500:
Info: filter timeout pid 0x0011
Info: filter timeout pid 0x0000
Info: filter timeout pid 0x0010
tune to: :650000:I999B8C999D999M999T999G999Y999:T:27500:
Info: filter timeout pid 0x0011
Info: filter timeout pid 0x0000
Info: filter timeout pid 0x0010
tune to: :714000:I999B8C999D999M999T999G999Y999:T:27500:
Info: filter timeout pid 0x0011
Info: filter timeout pid 0x0000
Info: filter timeout pid 0x0010
dumping lists (0 services)
Done.

Patch for add support Compro Videomate e800 (dvt-t part only)

linux/Documentation/video4linux/CARDLIST.cx23885 +1 -0
diff -Naur a/linux/Documentation/video4linux/CARDLIST.cx23885 b/linux/Documentation/video4linux/CARDLIST.cx23885
@@ -16,3 +16,4 @@
  15 -> TeVii S470                                          [d470:9022]
  16 -> DVBWorld DVB-S2 2005                                [0001:2005]
  17 -> NetUP Dual DVB-S2 CI                                [1b55:2a2c]
+ 18 -> Compro VideoMate E800                               [1858:e800]
linux/drivers/media/video/cx23885/cx23885-cards.c +12 -0
diff -Naur a/linux/drivers/media/video/cx23885/cx23885-cards.c b/linux/drivers/media/video/cx23885/cx23885-cards.c
@@ -182,6 +182,10 @@
 		.portb		= CX23885_MPEG_DVB,
 		.portc		= CX23885_MPEG_DVB,
 	},
+        [CX23885_BOARD_COMPRO_VIDEOMATE_E800] = {
+		.name		= "Compro VideoMate E800",
+		.portc		= CX23885_MPEG_DVB,
+	},
 };
 const unsigned int cx23885_bcount = ARRAY_SIZE(cx23885_boards);
 

@@ -281,6 +285,10 @@
 		.subvendor = 0x1b55,
 		.subdevice = 0x2a2c,
 		.card      = CX23885_BOARD_NETUP_DUAL_DVBS2_CI,
+        }, {
+		.subvendor = 0x1858,
+		.subdevice = 0xe800,
+		.card      = CX23885_BOARD_COMPRO_VIDEOMATE_E800,
 	},
 };
 const unsigned int cx23885_idcount = ARRAY_SIZE(cx23885_subids);

@@ -435,6 +443,7 @@
 	case CX23885_BOARD_HAUPPAUGE_HVR1500Q:
 	case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H:
 	case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:
+        case CX23885_BOARD_COMPRO_VIDEOMATE_E800:
 		/* Tuner Reset Command */
 		bitmask = 0x04;
 		break;

@@ -576,6 +585,7 @@
 		break;
 	case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H:
 	case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:
+        case CX23885_BOARD_COMPRO_VIDEOMATE_E800:
 		/* GPIO-2  xc3028 tuner reset */
 
 		/* The following GPIO's are on the internal AVCore (cx25840) */

@@ -724,6 +734,7 @@
 	case CX23885_BOARD_HAUPPAUGE_HVR1400:
 	case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H:
 	case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:
+        case CX23885_BOARD_COMPRO_VIDEOMATE_E800:
 	default:
 		ts2->gen_ctrl_val  = 0xc; /* Serial bus + punctured clock */
 		ts2->ts_clk_en_val = 0x1; /* Enable TS_CLK */

@@ -740,6 +751,7 @@
 	case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H:
 	case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:
 	case CX23885_BOARD_NETUP_DUAL_DVBS2_CI:
+        case CX23885_BOARD_COMPRO_VIDEOMATE_E800:
 		dev->sd_cx25840 = v4l2_i2c_new_subdev(&dev->v4l2_dev,
 				&dev->i2c_bus[2].i2c_adap,
 				"cx25840", "cx25840", 0x88 >> 1);
linux/drivers/media/video/cx23885/cx23885-dvb.c +1 -0
diff -Naur a/linux/drivers/media/video/cx23885/cx23885-dvb.c b/linux/drivers/media/video/cx23885/cx23885-dvb.c
@@ -565,6 +565,7 @@
 	}
 	case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H:
 	case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:
+        case CX23885_BOARD_COMPRO_VIDEOMATE_E800:
 		i2c_bus = &dev->i2c_bus[0];
 
 		fe0->dvb.frontend = dvb_attach(zl10353_attach,
linux/drivers/media/video/cx23885/cx23885.h +1 -0
diff -Naur a/linux/drivers/media/video/cx23885/cx23885.h b/linux/drivers/media/video/cx23885/cx23885.h
@@ -72,6 +72,7 @@
 #define CX23885_BOARD_TEVII_S470               15
 #define CX23885_BOARD_DVBWORLD_2005            16
 #define CX23885_BOARD_NETUP_DUAL_DVBS2_CI      17
+#define CX23885_BOARD_COMPRO_VIDEOMATE_E800    18
 
 /* Currently unsupported by the driver: PAL/H, NTSC/Kr, SECAM B/G/H/LC */
 #define CX23885_NORMS (\

-------- Завершение пересылаемого сообщения --------

_______________________________________________
linux-dvb users mailing list
For V4L/DVB development, please use instead [email protected] [email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb