I2C: Change the value of octeon i2c adapter timeout value
Quoted 4 lines · EUNBONG SONG
Quoted 2 lines
I think HZ/50 is better than 2 for adapter timeout.
Basically OK. But why HZ/50? Most drivers use HZ.
Actually, I just translated 2 jiffies because HZ is 100 in default cavium config. You can find that in "arch/mips/configs/cavium_octeon_defconfig". And i have been using this value over 1 year in octeon board without problem. Thanks.
Quoted 11 lines · EUNBONG SONG
Quoted 4 lines · EUNBONG SONG
Quoted 2 lines
I think HZ/50 is better than 2 for adapter timeout.
Basically OK. But why HZ/50? Most drivers use HZ.
Actually, I just translated 2 jiffies because HZ is 100 in default cavium config. You can find that in "
arch/mips/configs/cavium_octeon_defconfig". And i have been using this value over 1 year in octeon board without problem.
Have you been writing to EEPROMS? Their erase/write cycle might be longer. But I am not forcing you to change the value, just giving some suggestions.