Skip to contentSkip to conversation

QCA4019 firmware: wrong numChain setting for bmi-board 16+17

DISCUSSION Sven Eckelmann 1 participant 2 messages Feb 8, 2017 – Mar 3, 2017 Qualcomm Atheros ATH10K wireless driver

lore
Share & tools
lore
#0 lore raw

Hi,

I've just noticed that the numChain in (ath10k/)QCA4019/hw1.0/board-2.bin is wrong in the bus=ahb,bmi-chip-id=0,bmi-board-id=16 and bus=ahb,bmi-chip-id=0,bmi-board-id=17 from the linux-firmware and ath10k-firmware repository. It is 0x4 for a 2x2 device. This was fixed in the QSDK by commit 171b9607fb8cc694ed469a4e29c91af9d92f2971 [1]. It is not known to me whether this has an effect when the pre-cal data says that the device should use numChain 2.

It is also currently unknown if this is actually the correct fieldname (it is just called numChain_A_0_0 [2] in some text files we got from the netgear GPL drop [2]). But I am talking about the byte at offset 0x2771. The only other change in these two boarddata sections is the CRC.

Kind regards,
Sven

[1] https://source.codeaurora.org/quic/qsdk/oss/firmware/ath10k-firmware/commit/ath10k/QCA40XX/hw1.0/board-2.bin?id=171b9607fb8cc694ed469a4e29c91af9d92f2971
[2] https://github.com/paul-chambers/netgear-r7800/blob/master/git_home/madwifi-11n.git/halphy_tools/host/eepromUtil/release_ipq4019/boardData_1_0_IPQ4019_Y9803_wifi1.txt

_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k

#1 lore raw
Quoted 9 lines · On Mittwoch, 8. Februar 2017 11:40:07 CET Sven Eckelmann wrote:

Hi,

I've just noticed that the numChain in (ath10k/)QCA4019/hw1.0/board-2.bin is wrong in the bus=ahb,bmi-chip-id=0,bmi-board-id=16 and bus=ahb,bmi-chip-id=0,bmi-board-id=17 from the linux-firmware and ath10k-firmware repository. It is 0x4 for a 2x2 device. This was fixed in the QSDK by commit 171b9607fb8cc694ed469a4e29c91af9d92f2971 [1]. It is not known to me whether this has an effect when the pre-cal data says that the device should use numChain 2.

I was informed that the numChain information is part of the pre-calibration data. So it is most likely only relevant when you calibrate your board or don't have pre-calibration data.

Kind regards,
Sven

_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k