Skip to contentSkip to conversation

Q: Register usage in mpc860 ports

DISCUSSION Jim Chapman 2 participants 2 messages May 21, 1999

lore
Share & tools
lore
#0 lore raw

I am porting LinuxPPC to a custom embedded mpc860 board. I am starting with the mbx port and using home-built egcs-1.1.2 tools on a Linux host, using the instructions in
http://members.home.com/mmporter/cross.html

There seem to be register usage conflicts in the MMU TLB handlers. The code tries to use location 0 (according to the comment) to store a couple of register values, e.g. in arch/ppc/kernel/head.S

InstructionTLBMiss:
mtspr M_TW, r20 /* Save a couple of working registers */ mfcr r20
stw r20, 0(r0)
stw r21, 4(r0)

However, I am finding that r0 isn't zero when the MMU exceptions are taken. Instead, it points to somewhere in the text or data segment. I hacked the code to save r20 & r21 to a specific memory location and that fixed that particular problem.

Has anyone else seen this sort of thing when doing a custom port? Perhaps this is being caused by an init problem since the MBX comments suggest that E-PPCbug is used to download and init that card but I don't use EPPCbug? What registers are reserved by the kernel in the MBX port, apart from r2? What mpc860 register setup should be done in head.S before going to C?

Thanks

Jim

[[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. Please check http://lists.linuxppc.org/ ]]
[[ and http://www.linuxppc.org/ for useful information before posting. ]]

#1 lore raw
Quoted 15 lines · Jim Chapman

I am porting LinuxPPC to a custom embedded mpc860 board. I am starting with the mbx port and using home-built egcs-1.1.2 tools on a Linux host, using the instructions in
http://members.home.com/mmporter/cross.html

There seem to be register usage conflicts in the MMU TLB handlers. The code tries to use location 0 (according to the comment) to store a couple of register values, e.g. in arch/ppc/kernel/head.S

InstructionTLBMiss:
mtspr M_TW, r20 /* Save a couple of working registers */ mfcr r20
stw r20, 0(r0)
stw r21, 4(r0)

Quoted 4 lines

However, I am finding that r0 isn't zero when the MMU exceptions are taken. Instead, it points to somewhere in the text or data segment. I hacked the code to save r20 & r21 to a specific memory location and that fixed that particular problem.

r0 represents 0 in a number of PPC instructions, lookup stw in your PPC assembler book.

Franz.

[[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. Please check http://lists.linuxppc.org/ ]]
[[ and http://www.linuxppc.org/ for useful information before posting. ]]