Skip to contentSkip to conversation

Finally ... Kernel Booted on C200

parisc-linux Ryan Bradetich 1 participant 1 message Sep 9, 1999

lore
Share & tools
lore
#0 lore raw

Well I'm slowly learning .... :)

I finally figured out how to compile the cvs tree into a kernel that I could boot on the C200.
These are the steps I followed, will someone verify if they are correct?

1. built the kernel using vmlinux,
2. built the ipl in arch/parisc/boot/boot_code
3. stripped ipl
4. mkImage ipl vmlinux vmlinux.boot
5 boot off of vmlinux.boot

At this point I get Tranfering control to kernel. (At entry point 0x00010000)
The LED are also flashing in some patteren.

Well, time to start researching signals :)

-Ryan