pci 1520-compact flash Detection
Hi , Through PCI 1520 am detecting compact flash presence..u-boot does nand
probing then if try
command nand read <...> or nand write <....> says error , any one has
faced problem like this ....
How to verify read/write blocks on CF.
Kind Regards,
Rangaraju.
--
View this message in context: http://www.nabble.com/pci-1520-compact-flash-Detection-t1428672.html#a3853180
Sent from the Uboot - Users forum at Nabble.com.
Quoted 5 lines · In message <[email protected]> you wrote:
Hi , Through PCI 1520 am detecting compact flash presence..u-boot does nand probing then if try
command nand read <...> or nand write <....> says error , any one has faced problem like this ....
Compact Flash support has nothing to do with NAND. You must be mixing unrelated code and/or events here.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "What if" is a trademark of Hewlett Packard, so stop using it in your sentences without permission, or risk being sued.
Hi Sry for the confusion!
i am trying to access compact flash with the config mentioned below. & i get error like Bus o not available any thing am missing in configuration, but interface detects sandisk (i have 512MB CF)
#define CONFIG_I82365
#define PCMCIA_MEM_BASE 0xe0002000 /* PCMCIA memory window base */
#define CFG_PCMCIA_MEM_ADDR PCMCIA_MEM_BASE
#define CFG_PCMCIA_MEM_SIZE 0x00100000
#define CONFIG_IDE_8xx_PCCARD 1 /* Use IDE with PC Card Adapter
*/
#undef CONFIG_IDE_8xx_DIRECT /* Direct IDE not supported */ #undef CONFIG_IDE_RESET /* reset for IDE not supported */ #undef CONFIG_IDE_LED /* LED for IDE is supported */
#define CFG_IDE_MAXBUS 1 /* max. 1 IDE bus */
#define CFG_IDE_MAXDEVICE 1 /* max. 1 drive per IDE bus */
#define CFG_ATA_BASE_ADDR CFG_PCMCIA_MEM_ADDR
#define CFG_ATA_IDE0_OFFSET 0x0000
#define CFG_ATA_DATA_OFFSET 0
#define CFG_ATA_REG_OFFSET 0
#define CFG_ATA_ALT_OFFSET 0x200
PCMCIA:Enable PCMCIA slot A
3.3V card found Ext: Compact Flash Card ready for data
## Config_base = 0200 ###
SanDisk SDP 5/3 0.6
## Compare against "ARGOSY PnPIDE D5"
Fixed Disk Card
IDE interface
[silicon] [unique] [single] [sleep] [standby] [idle] [low power]
Bus 0: not available
--
View this message in context: http://www.nabble.com/pci-1520-compact-flash-Detection-t1428672.html#a3870616
Sent from the Uboot - Users forum at Nabble.com.