How to set serial console on 712 (fwd)
I seem to have managed to set my console on my 712 to be neither serial or graphics. When HPUX boots it seems to detect the console is serial and I get a login prompt and console messages on my serial terminal, but it is not really the console as I see no messages from ISL etc on the serial port.
I think I incorrectly typed the console path when I changed it :( .
The machine boots fine and I can telnet to it etc, but I have no way of accessing the PDC/ISL. Before I managed to do this I upgraded it to the lastest firmware.
Is there some HPUX (10.20) command or trick to alter PDC? ISL? information to reset my console to a sane state?
I have tried unplugging the keyboard/disks/LAN pretty much everything really to try to reset it to some factory default.
Thanks.
[parisc-linux] Firmware (was How to set serial ..)
Quoted 2 lines · Tom Gallagher
... Before I managed to do this I upgraded it to the lastest firmware.
How does one do that?
Re: [parisc-linux] Firmware (was How to set serial ..)
Making, drinking tea and reading an opus magnum from Sandy Harris:
Quoted 6 lines
Quoted 2 lines · Tom Gallagher
... Before I managed to do this I upgraded it to the lastest firmware.
How does one do that?
there is a bootable image somewhere on hp site.
one should boot either from spare disk or over the network. the image itself will perform an upgrade.
one caution, it upgrades the graphics eprom as well and changes the video mode.
the cure is to type blindly the boor_admin command to change to whatever resolution one had before the upgrade.
cu
Signature · 1 line
paranoic mickey (my employers have changed but, the name has remained)