More Compact Flash Problems
When I copy a file system to the CF, some cards work, some do not.
A problem I've noticed:
1. copy files from image fs (27MB of files) to mnt (mount point of CF)
2. sync / umount / mount
3. diff -rq mnt image reports files different
One file in particular, on one card, always comes up different:XF86_SVGA
If I delete that file and copy the original one again, the above steps can be
repeated...same problem.
However, if I move that file to xxxx then copy XF86_SVGA (this prevents me
from using the original blocks used by XF86_SVGA) - Now it works!!
So, I conclude that either:
A. there are bad blocks on the CF device that linux is not aware of B. the write operation is not fully supported with CF and the IDE driver
Which leads to a few questions:
1. Can you actually find bad blocks on a device ? (mkfs -c didn't seem to help)
2. Are these cards manufactured with a list of bad blocks ??
3. Is there any way to slow down the copy operation ? (maybe this is not supporting the copying of large files - some flash blocks may take longer to
write than others - moon phase may be a factor here :)
4. Will the nftl drivers work for CF ??
Any help on this would be greatly appreciated!
Thanks,
Ralph
To unsubscribe, send "unsubscribe mtd" to [email protected]