Skip to contentSkip to conversation

Putting linuxPPC on my new pismo

DISCUSSION Francis G. McCabe 3 participants 3 messages Apr 19, 2000

lore
Share & tools
lore
#0 lore raw

I realize that there has been a lot of discussion about this. However, I havent seen my problem mentioned.

When I try to install linuxPPC 2000 on my brand new PB2000, I get the error:

hda: lost interrupt

Any suggestions?

I am reasonably familiar with linux on intel systems, and have installed linuxPPC on my wife's iMac, but I dont know where to go from here...

begin:vcard
n:McCabe;Francis
tel;cell:650 740 6673
tel;work:408 530 4549
x-mozilla-html:FALSE
org:Fujitsu Labs of America
adr:;;595 Lawrence Expressway;Sunnyvale;CA;94086;USA version:2.1 email;internet:[email protected] x-mozilla-cpt:;9040
fn:Francis G. McCabe
end:vcard

#1 lore raw
Quoted 7 lines · Francis G. McCabe

I realize that there has been a lot of discussion about this. However, I havent seen my problem mentioned.

When I try to install linuxPPC 2000 on my brand new PB2000, I get the error:

hda: lost interrupt

If you searched the archives for your error message, you would find the answer you seek (it is not a powerbook only problem).

Make sure you are using yaboot to boot the powerbook, not bootX. Using bootX on the newworld machines causes that problem to occur.

HTH
--Nelson Abramson

--
"Apparently if you play the Windows NT CD backwards you hear satanic messages" "You think that's bad, if you play it forwards it installs Windows NT!" --orlando

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

#2 lore raw
In reply to Francis G. McCabe
Quoted 7 lines · Francis G. McCabe

I realize that there has been a lot of discussion about this. However, I havent seen my problem mentioned.

When I try to install linuxPPC 2000 on my brand new PB2000, I get the error:

hda: lost interrupt

Don't use BootX; you have to use yaboot.

-Hollis

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/