CFI chip detection
Hi,
In cfi_cfi_probe() there is
for (base = (1<<cfi.chipshift) * cfi.interleave; base < map->size; base += (1<<cfi.chipshift) * cfi.interleave) cfi_probe_new_chip(map, base, &chip[0], &cfi); ...
to detect aditional chips. However is did not work on the board I have (SBC-MediaGX). Removing the `* cfi.interleave' caused additional chips to be detected. Is this a quirk particular to this board or is the above code wrong?
The SBC-MediaGX has:
1x 28F640 in x8 mode for the 8 Mbyte board
2x 28F640 in x8 mode for the 16 Mbyte board
David Vrabel
To unsubscribe, send "unsubscribe mtd" to [email protected]
Quoted 7 lines · [email protected] said:
Removing the `* cfi.interleave' caused additional chips to be
detected. Is this a quirk particular to this board or is the above code wrong?The SBC-MediaGX has:
1x 28F640 in x8 mode for the 8 Mbyte board
2x 28F640 in x8 mode for the 16 Mbyte board
Odd. How exactly are the chips mapped in the 16 MB board? Are they interleaved, or just concurrently mapped?
Can you show the output when it fails to detect the second chip?
--
dwmw2
To unsubscribe, send "unsubscribe mtd" to [email protected]