Skip to contentSkip to conversation

usb chipset

DISCUSSION Gary Swanson 2 participants 2 messages Aug 24, 2000

lore
Share & tools
lore
#1 lore raw
In reply to Gary Swanson

Hi,

I nearly have the same problem. I need USB support for an PPC405CR platform ! As far as I know. only PCI USB chipsets (OHCI/UHCI) are supported by linux. It is also a little problem to get usb host controller other than PCI chips (I am not sure if you need a masteror slave chip). But a solution seams to be at the horizont.
The USB host/slave chips from scanlogic (SL11H/S and SL811). I read that softconnex will write some linux drivers for those chips. But I am sure, not under the GPL. So it would be nice if someone would do that under the GPL.

Matthias

Quoted 9 lines · Gary Swanson

Hello,

I hope this isn't an inappropriate newbie question, but here goes.

We have been developing solutions using a PowerPC823, which has on chip USB support, but we are starting another development with the PowerPC 855, which I understand doesn't have on-chip USB support.

Quoted 9 lines

My question is; are there external USB chipsets that we can use that are already supported by the 2.2.14 kernel (from the MontaVista CDK 1.2), or does anyone have any recommendations for a chipset that would make the USB support as straightforward as possible ?

Thank you,

Gary

--
-------------------------------------------------
\ Matthias Fuchs \
\ esd electronic system design Gmbh \
\ Vahrenwalder Straße 205 \

   \ D-30165 Hannover                               \
    \ email: [email protected]      \
     \ phone: +49-511-37298-0                         \
      \ fax:   +49-511-37298-68                        \
       --------------------------------------------------

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#0 lore raw

Hello,

I hope this isn't an inappropriate newbie question, but here goes.

We have been developing solutions using a PowerPC823, which has on chip USB support, but we are starting another development with the PowerPC 855, which I understand doesn't have on-chip USB support.

My question is; are there external USB chipsets that we can use that are already supported by the 2.2.14 kernel (from the MontaVista CDK 1.2), or does anyone have any recommendations for a chipset that would make the USB support as straightforward as possible ?

Thank you,

Gary

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/