egcs 1.0.3a build error?
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hello,
Quoted 2 lines
Thank you, I tried that and had the same result?? Maybe there are other CFLAGS that I need to specify?
Don't think so...it worked for me, but this was CVS GCC, not 1.0.3a. I have had no such problems with 1.0.3a.
Quoted 1 line
CFLAGS=-O1
humm...I used CFLAGS="-O1"
donno what difference the quotes make, if any...
Quoted 1 line
--enable-languages=c c++
I use c,c++
You could also try just --enable-languages=c then using that to compile one with c,c++ I have done that in the past too!
Quoted 2 lines
Have you been successful in getting Egcs-1.0.3a-2 to build natively on a MIPS little endian system?
No, big endian. Have compiled on an Indy and an I2 loads of times...
Bye for Now,
Ian
\|||/
(o o)
/---------------------------ooO-(_)-Ooo---------------------------\
| Ian Chilton (IRC Nick - GadgetMan) ICQ #: 16007717 |
|-----------------------------------------------------------------|
| E-Mail: [email protected] Web: http://www.ichilton.co.uk |\-----------------------------------------------------------------/
Quoted 10 lines · Ian Chilton
Quoted 2 lines
Thank you, I tried that and had the same result?? Maybe there are other CFLAGS that I need to specify?
Don't think so...it worked for me, but this was CVS GCC, not 1.0.3a. I have had no such problems with 1.0.3a.
Quoted 1 line
CFLAGS=-O1
humm...I used CFLAGS="-O1"
donno what difference the quotes make, if any...
No difference.
In any case he seems to hit a different problem than the one you're refering to which only happens when using an old gcc suchs as egcs 1.0.3a without optimization for compilation of a fairly recent one.
Ralf