VFS Kernel Panic in 2.4.0-10(11)
This is probably a configuration mismatch of some kind, but I just finished building my 2.4.0 RPM skeletons and am installting them from our latest CD burn, and I am seeing the following
problem when I upgrade our 2.2.17 kernel versions with 2.4.0-test10, then reboot them under 2.4:
request_module[block-major-3]: Root fs not mounted VFS cannot open root device "301" or 03:01 Please append a correct "root=" boot option
Kernel panic: VFS: Unable to mount root fs on 03:01.
The system was running Ute-Linux under 2.2.17 then was upgraded to 2.4.0-10 (with IPVS and pre-11 patches).
The disk is a 20GB device with
/dev/hda1 Linux (/,/boot) at
3,1/dev/hda2 Extended (contains a swap partition /dev/hda5) at
3,2/dev/hda3 Linux (/usr) at
3,3/dev/hda4 Linux (/archive) at
3,4/dev/hda5 Swap Swap at
3,5
Lilo is configured in linear mode. The device it's complaining about is present
(03:01) and lilo does append a root=/dev/hda1 statement.
Any ideas?
Jeff
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
We dfound it. 2.2.X .configs are incompatible with 2.4.0 and the upgrade RPMs sucked them in. Since IDE is a unique CONFIG option, this will break.
Jeff
Quoted 32 lines · Jeff V. Merkey
This is probably a configuration mismatch of some kind, but I just finished building my 2.4.0 RPM skeletons and am installting them from our latest CD burn, and I am seeing the following
problem when I upgrade our 2.2.17 kernel versions with 2.4.0-test10, then reboot them under 2.4:request_module[block-major-3]: Root fs not mounted VFS cannot open root device "301" or 03:01 Please append a correct "root=" boot option
Kernel panic: VFS: Unable to mount root fs on 03:01.The system was running Ute-Linux under 2.2.17 then was upgraded to 2.4.0-10 (with IPVS and pre-11 patches).
The disk is a 20GB device with
/dev/hda1Linux (/,/boot) at
3,1/dev/hda2Extended (contains a swap partition/dev/hda5) at
3,2/dev/hda3Linux (/usr) at
3,3/dev/hda4Linux (/archive) at
3,4/dev/hda5Swap Swap at
3,5Lilo is configured in linear mode. The device it's complaining about is present
(03:01) and lilo does append a root=/dev/hda1 statement.
Quoted 7 lines
Any ideas?
Jeff
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
Quoted 11 lines · Jeff V. Merkey
This is probably a configuration mismatch of some kind, but I just finished building my 2.4.0 RPM skeletons and am installting them from our latest CD burn, and I am seeing the following
problem when I upgrade our 2.2.17 kernel versions with 2.4.0-test10, then reboot them under 2.4:request_module[block-major-3]: Root fs not mounted VFS cannot open root device "301" or 03:01 Please append a correct "root=" boot option
Kernel panic: VFS: Unable to mount root fs on 03:01.
IDE built as module. Root on IDE disk. Apparently, no initrd in sight. Check your .config and either don't make IDE a module or enable initrd and make sure to put the modules into initrd image.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/