Skip to contentSkip to conversation

64 bit memory access

DISCUSSION Tim Montgomery 3 participants 3 messages Dec 29, 2000

lore
Share & tools
lore
#0 lore raw

Hello,

I have a quandary.

My platform is a PowerPC (MPC750) based embedded machine.

I have a device (memory-mapped) that I need to access that lives on an internal peripheral bus but has the unfortunate constraint of allowing only 64bit-wide writes. Any write of a smaller width results in an exception generated by the memory controller.

Drivers exist for this device for other, lesser OSs that use FP regs to write the 64bit quantity to the bus (using lfd and stfd). However, from what I gather, using the FP regs in kernel drivers under Linux kernel (2.4.0test12-based) seems to be a no-no.

I am afraid I am at an impasse.

I need to:
1.) figure out a way to perform a 64bit write via other means OR
2.) make sure I don't screw up user mode FP usage (potential consequence of dinking with FP while in the kernel?)

Any suggestions/insight would be appreciated.

Regards,
Tim

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

#1 lore raw
Quoted 2 lines · Tim Montgomery

I need to:
1.) figure out a way to perform a 64bit write via other means

Cache the location. When you access the space the processor will do a 64-bit read. You will have to run in copyback mode then when done updating the location push the cache line to the device.

Quoted 1 line

Any suggestions/insight would be appreciated.

Using 64-bit only I/O, and FP registers on a 32-bit processor is an interesting hardware/software hack, but not a very good system design.

I guess we could write some kernel 64-bit I/O functions that use an FP register. This would require disabling interrupts, enabling the FPU in the kernel, saving a register, doing the I/O, restoring the register, disabling the FPU, and enabling interrupts. Not very efficient when a proper 60x bus implementation that allowed sizing would have been really fast.........

	-- Dan

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

#2 lore raw
Quoted 1 line · Dan Malek

Tim Montgomery wrote:

[...]

Quoted 6 lines
Quoted 1 line

Any suggestions/insight would be appreciated.

Using 64-bit only I/O, and FP registers on a 32-bit processor is an interesting hardware/software hack, but not a very good system design.

Quoted 6 lines

I guess we could write some kernel 64-bit I/O functions that use an FP register. This would require disabling interrupts, enabling the FPU in the kernel, saving a register, doing the I/O, restoring the register, disabling the FPU, and enabling interrupts. Not very efficient when a proper 60x bus implementation that allowed sizing would have been really fast.........

I'm almost tempted to say that the classic BSD-ish meme might apply here:

Q: How do I work around XYZ hardware bogosity?
A: Buy better hardware.

But of course, back in the world of linux, the "We Luv Everybody" OS, hope still lays in the form of unmergable patchsets, but I would be dissapointed if IO functions like these were to their way into any mainstream kernel.

Cheers - Tony 'Nicoya' Mantler :)

--
Tony "Nicoya" Mantler - Renaissance Nerd Extraordinaire - [email protected]
Winnipeg, Manitoba, Canada -- http://nicoya.feline.pp.se/

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/