Skip to contentSkip to conversation

partitions for RAID volumes?

DISCUSSION rayn 1 participant 2 messages Feb 21, 2001

lore
Share & tools
lore

rayn

author
#0 lore raw

Hi,

Is there any chance that RAID volumes would support partitions like the hard-disk driver in the future? This could be handsome if you try to program a kernel driver for any of those RAID adapters (e.g. thinking of those Fasttrack or Highpoint lowcost IDE controllers). A RAID personality could take over all the controller specific stuff. I have done this for the Highpoint HTP370, which is found on some of the new ABIT mainboards. I am running a dualboot system (Win98/Linux) on one RAID volume with two partitions (a swap partition is not supported on raid devices). And LILO boots it! *joy*
I have created a patch for this which applies to kernel 2.2.18. This does the partition trick and contains a mixture of the RAID-0 and RAID-1 code to do the disk striping (only disk striping is supported). So if anyone is interrested in the patch contact me. But be aware that installation is not a piece of cake!

Wilfried Weissmann

author
#1 lore raw
Quoted 10 lines · Jeremy Jackson
Quoted 4 lines · rayn

Hi,

Is there any chance that RAID volumes would support partitions like the hard-disk driver in the future? This could be handsome if you try to

You may wish to try LVM in kernel 2.4.0. This is much more flexible for administration, but I don't know about windoze...

I agree. I know LVM from HP-UX and it works absolutely flawless there. But when it comes to dualbooting several OSes like Linux and Win* I do not think that you have a chance with LVM (unless all OSes support the same LVM standard. Microsoft pops in my mind!).

Wilfried Weissmann