Promise Ultra100 IDE PDC20265 chip problem
Quoted 1 line · [email protected] wrote:
(I am not subscribed to this list, if it is in fact a list. Please CC
any
Quoted 3 lines
replies to me directly - Thanks)
I am attempting to install the new beta release of Red Hat (fisher) on
my
Quoted 1 line
home computer. It has an Asus A7V motherboard and a Promise Ultra100
IDE
Quoted 1 line
controller (PDC20265 chip), with two partitions. Windows ME is
installed in
Quoted 1 line
the first partition. The second one is where I'm attempting to install
Red
Quoted 3 lines
Hat.
In previous releases of the Linux kernel, my hard drive was not seen
at all.
Quoted 1 line
I could go all the way up to the point in the Red Hat installation
where it
Quoted 1 line
wanted to do disk geometry, and then said that I didn't have any mass
media
Quoted 3 lines
device. Searching through various mail archives lead me to believe the
culprit was the PDC20265 controller chip and the fact that it was too
new to
Quoted 3 lines
be recognized.
In the new kernel 2.4.0 (and thereby the fisher release of Red Hat), I
now
Quoted 1 line
see the error below printed out to the console when booting from the
Red Hat
Quoted 1 line
installation floppy. After the error is printed out, my computer
hangs. I
Quoted 1 line
apologize in advance if this is not a Linux kernel issue, and
appreciate any
Quoted 9 lines
help that can be provided.
--Pete
[snip]
PDC 20265: chipset revision 2
PDC 20265: not 100% native mode: will probe irqs later
Quoted 7 lines
[snip]
Partition Check:
hde: [PTBL] [1826/255/63] hde1 hde2 < hde5hde:dma_intr: status=0x51 {DriveReady SeekComplete Error }
hde:dma_intr: error=0x10 { SectorIdNotFound }, LBAsect=32885055,
sector=0
Quoted 6 lines
hde:
dma_intr: status=0x51 { DriveReady SeekComplete Error }[last repeats 3-4 times]
hde: DMA disabled
this looks like a sign that the kernel you're using is configured to try to use
harddisk DMA right at boot. That *could* cause problems in rare cases. SectorIdNotFound looks like a bad sector on the harddisk though. looks like you can't get into linux at all... try scandisk from windows on Thorough setting (have to format linux partition as fat32 first).