Skip to contentSkip to conversation

How to set hdparms for ide-scsi devices on devfs?

DISCUSSION Jeremy Jackson 1 participant 1 message Mar 1, 2001

lore
Share & tools
lore
#0 lore raw
Quoted 17 lines · Eduard Hasenleithner

Sorry, if this issue was already discussed in lkml. I didn't find a reference to this at www.geocrawler.com

My Problem:
I want to set the unmaskirq and dma -flag for my ide cd-recorder. The Problem is, that devfs creates no ide device, but only the /dev/scsi/../{cd,general} devices are created. And hdparm don't accepts this devices for setting the ide-parameters.

My current workaround is to create a /dev/hd? device "by hand" at system startup. This is not very beautiful. Furthermore, if the device numbers in devfs are deactivated, this won't work anymore.

I can live with my current solution. But i would be very happy if someone can present a clean solution.

Quoted 8 lines

I posted this message intentionally not on the devfs mailing list as i think this problem is related to accessing the same device through different /dev entries. Under devfs, the /dev/ide/... device node gets allocated after the corresponding ide-xx.o has been loaded. But this is not possible with ide-scsi claiming the device :(

Thanks in advance

workaround - before ide-scsi is loaded in boot sequence (finding is left as an exercise to the reader :) do:

modprobe ide-cd
hdparm -u 1 -d 1 /dev/xxx
rmmod ide-cd

might have to do near top of /etc/rc.d/rc.sysinit under redhat, but this is good since problems will happen before root filesystem is remounted read-write, so any problems with hdparm settings won't mess up disk.