2.4.2 SMP + 3c905C-TX + NETDEV WATCHDOG
Every few weeks, since switching to 2.4.2, I get a series of 'NETDEV WATCHDOG' errors. When this happens the system becomes unusable (homes are NFS mounted) and does not recover. A small number of packets do get out when it's in this state, but not enough to be useful. I've tried an ifconfig up/down, all that seems to help is a reboot. The 3c905C driver is compiled into my kernel, so I can't reload it. The machine is a Dell Precision 220 (only one processor installed).
Has anyone else seen this problem. Is their a way to reset the interface without rebooting? Any ideas?
Many thanks,
Clem
NETDEV WATCHDOG: eth0: transmit timed out
eth0: transmit timed out, tx_status 00 status e601.
diagnostics: net 0cfc media 8880 dma 0000003a.
eth0: Interrupt posted but not delivered -- IRQ blocked by another device?
Flags; bus-master 1, full 0; dirty 1172221(13) current 1172221(13). Transmit list 00000000 vs. c14ca2d0.
0: @c14ca200 length 8000002a status 0001002a 1: @c14ca210 length 8000008e status 0001008e 2: @c14ca220 length 800000ae status 000100ae 3: @c14ca230 length 8000006e status 0001006e 4: @c14ca240 length 800000ae status 000100ae 5: @c14ca250 length 800000ae status 000100ae 6: @c14ca260 length 8000004a status 0001004a 7: @c14ca270 length 8000008e status 0001008e 8: @c14ca280 length 800000ae status 000100ae 9: @c14ca290 length 8000002a status 0001002a 10: @c14ca2a0 length 8000002a status 0001002a 11: @c14ca2b0 length 8000004a status 8001004a 12: @c14ca2c0 length 8000002a status 8001002a 13: @c14ca2d0 length 80000042 status 00010042 14: @c14ca2e0 length 800000ae status 000100ae 15: @c14ca2f0 length 80000042 status 00010042
eth0: Resetting the Tx ring pointer.
Quoted 8 lines · Clem Taylor
Every few weeks, since switching to 2.4.2, I get a series of 'NETDEV WATCHDOG' errors. When this happens the system becomes unusable (homes are NFS mounted) and does not recover. A small number of packets do get out when it's in this state, but not enough to be useful. I've tried an ifconfig up/down, all that seems to help is a reboot. The 3c905C driver is compiled into my kernel, so I can't reload it. The machine is a Dell Precision 220 (only one processor installed).
Irritating, isn't it?
Quoted 2 lines
Has anyone else seen this problem. Is their a way to reset the interface without rebooting? Any ideas?
No. A reboot is required.
It is due to a problem in the APIC handling. There is a workaround in the 2.4.2-ac series which fixes it. It appears to not be in the 2.4.3 series. So for the while you'll have to either install a recent -ac kernel or boot with the `noapic' LILO option.
-