bootloader for deeply embedded 405CR
Hello linuxppc-embedded,
I am attempting to boot Montavista's PPC405 Linux port on a very minimal 405CR Rev C target: essentially, there's 64MB of SDRAM and a minicom on UART0. I have a 405GP kernel loading great on the Walnut board using the IBM serial monitor and treeboot, but I'm unsure what I need to do on the CR before I can begin successfully running Linux on it. I am using an Abatron BDI2000 along with GDB to load code and tweak registers on the target.
Right now, I am configuring the SDRAM controller and UART0, but apparently that is not sufficient to fully boot Linux, since I never get any output on the serial port except for the 'a' debug printout I enabled in head_4xx.S
Does anyone have a minimal 405GP/CR bootloader that I could use as an example? Or perhaps a FAQ on how to bring up a deeply embedded 405 using the Abatron box?
Thanks,
Bryan Rittmeyer
--
Bryan Rittmeyer
mailto:[email protected]
Ixia Communications
26601 W. Agoura Rd.
Calabasas, CA 91302
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Dear Bryan,
Quoted 4 lines · in message <[email protected]> you wrote:
Does anyone have a minimal 405GP/CR bootloader that I could use as an example? Or perhaps a FAQ on how to bring up a deeply embedded 405 using the Abatron box?
Did you try to run our Open Source Firmware "PPCBoot" on your board? The Walnut is one of the many supported configurations.
See the project page at ppcboot.sourceforge.net, which points you to the CVS server on sourceforge or our FTP server at ftp://ftp.denx.de/pub/ppcboot/
For PPCBoot related questions you can subscribe to the PPCBoot mailing list ([email protected]).
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] Contrary to popular belief, thinking does not cause brain damage.
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 7 lines
Quoted 4 lines
Does anyone have a minimal 405GP/CR bootloader that I could use as an example? Or perhaps a FAQ on how to bring up a deeply embedded 405 using the Abatron box?
Did you try to run our Open Source Firmware "PPCBoot" on your board? The Walnut is one of the many supported configurations.
Yes, you should give PPCBoot a try. There is also a PPC405CR implementation available - "canbt". This board is running PPCBoot as a boot loader firmware and Linux as OS.
Stefan Roese
*******************************************
esd gmbh
Vahrenwalder Str. 205
D-30165 Hannover
Phone: +49-511-37298-0 Fax: +49-511-37298-198 email: [email protected] www: http://www.esd-electronics.de
*******************************************
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/