Skip to contentSkip to conversation

Followup to previous post: Atlon/VIA Instabilities

DISCUSSION Manfred Spraul 3 participants 3 messages May 1, 2001 – May 2, 2001

lore
Share & tools
lore
#0 lore raw
Quoted 5 lines

So it seems that CONFIG_X86_USE_3DNOW is simply used to enable access to the routines in mmx.c (the athlon-optimized routines on CONFIG_K7 kernels), so then it appears that somehow this is corrupting memory / not behaving as it should (very technical, right?) :)...

Do you use any unusual (binary only/with source) kernel modules?

mmx.c stores the current contents on the fpu registers into current->thread.i387.f{,x}save.
If another module modifes the fpu registers and calls memmove it will cause fpu corruptions.

I checked that a few months ago, and no module in the main kernel tree does that.

--
Manfred

#1 lore raw
Quoted 9 lines · Manfred Spraul
Quoted 6 lines

So it seems that CONFIG_X86_USE_3DNOW is simply used to enable access to the routines in mmx.c (the athlon-optimized routines on CONFIG_K7 kernels), so then it appears that somehow this is corrupting memory / not behaving as it should (very technical, right?) :)...

Do you use any unusual (binary only/with source) kernel modules?

Quoted 7 lines

mmx.c stores the current contents on the fpu registers into current->thread.i387.f{,x}save.
If another module modifes the fpu registers and calls memmove it will cause fpu corruptions.

I checked that a few months ago, and no module in the main kernel tree does that.

No, actually the instability starts right after/when the root
filesystem is mounted (it seems). I have no foreign modules installed when this error occurs. Even if I did, why would the Abit KA7 with the same [other] hardware and software NOT show this problem, even with all opts enabled?

--Seth

#2 lore raw
In reply to Manfred Spraul
Quoted 5 lines

No, actually the instability starts right after/when the root
filesystem is mounted (it seems). I have no foreign modules installed when this error occurs. Even if I did, why would the Abit KA7 with the same [other] hardware and software NOT show this problem, even with all opts enabled?

In my experience I've noticed motherboards can have a huge impact on
stability despite the chipsets, hardware used, etc. Abit is well known and liked in the overclocking circles, consequently I would strongly suspect that their motherboards are generally highly stable when compared to most others. In fact, my experience with them seams to support this thesis. Its possible that the other motherboard you were using is just flaky. Does the other one happen to be a PC-Chips one? These generally can be quite cheap, feature rich, and even have the best chipsets but still have proved themselves to be quite flaky to me in the past. FIC seams to have a similar problem, although they actually improve on their boards stability over time (have some rock solid high volume servers on "stabilized" FIC boards); sometimes with just a conveniently available BIOS update. Shuttle also seams to have gone downhill but that might have just been a one time occurrence.