Skip to contentSkip to conversation

pcmcia problems after upgrading from 2.4.3-ac7 to 2.4.4

DISCUSSION Martin.Knoblauch 3 participants 8 messages May 3, 2001 – May 7, 2001

lore
Share & tools
lore
#0 lore raw

Hi,

my DE-620 pccard stopped working after upgrading the kernel from
2.4.3-ac7 to 2.4.4. This is on a Toshiba 4080XCDT. I used the "good" .config from the 2.4.3-ac7 build to do a make "oldconfig". The symptoms at startup are:

Quoted 5 lines

PCMCIA: Starting services:
PCMCIA: using scheme: SuSE
/lib/modules/2.4.4/kernel/drivers/pcmcia/i82365.o: init_module: No such device
Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ >parameters /lib/modules/2.4.4/kernel/drivers/pcmcia/i82365.o: insmod >/lib/modules/2.4.4/kernel/drivers/pcmcia/i82365.o failed

Quoted 8 lines

/lib/modules/2.4.4/kernel/drivers/pcmcia/i82365.o: insmod i82365 failed /lib/modules/2.4.4/kernel/drivers/pcmcia/ds.o: init_module: Operation not permitted /lib/modules/2.4.4/kernel/drivers/pcmcia/ds.o: insmod >/lib/modules/2.4.4/kernel/drivers/pcmcia/ds.o failed /lib/modules/2.4.4/kernel/drivers/pcmcia/ds.o: insmod ds failed
cardmgr[189]: starting, version is 3.1.22
PCMCIA: cardmanager is running
cardmgr[189]: no pcmcia driver in /proc/devices
cardmgr[189]: exiting

As I said, worked fine until/including 2.4.3-ac7. Any ideas? And before
I forget, the base System is SuSe7.1 and all the packages mentioned in Documentation/Changes are at the required (or better) levels.

Martin

Signature · 5 lines
------------------------------------------------------------------
Martin Knoblauch         |    email:  [email protected]
TeraPort GmbH            |    Phone:  +49-89-510857-309
IT Services              |    Fax:    +49-89-510857-111
http://www.teraport.de   |    Mobile: +49-170-4904759

begin:vcard
n:Knoblauch;Martin
tel;cell:+49-170-4904759 tel;fax:+49-89-510857-111 tel;work:+49-89-510857-309
x-mozilla-html:FALSE
url:http://www.teraport.de
org:TeraPort GmbH;IT-Services
adr:;;Garmischer Straße 4;München;Bayern;D-80339;Germany version:2.1 email;internet:[email protected] title:Senior System Engineer x-mozilla-cpt:;32160
fn:Martin Knoblauch
end:vcard

#1 lore raw
Quoted 4 lines

my DE-620 pccard stopped working after upgrading the kernel from
2.4.3-ac7 to 2.4.4. This is on a Toshiba 4080XCDT. I used the "good" .config from the 2.4.3-ac7 build to do a make "oldconfig". The symptoms at startup are:

2.4.4 has older pcmcia than 2.4.3-ac7. It might be that. Does 2.4.4-ac work ?

#2 lore raw
Quoted 7 lines · Alan Cox
Quoted 5 lines

my DE-620 pccard stopped working after upgrading the kernel from
2.4.3-ac7 to 2.4.4. This is on a Toshiba 4080XCDT. I used the "good" .config from the 2.4.3-ac7 build to do a make "oldconfig". The symptoms at startup are:

2.4.4 has older pcmcia than 2.4.3-ac7. It might be that. Does 2.4.4-ac work ?

Alan,

thanks for replying. Which 2.4.4-ac would you recommend? BUT, I
actually think that the pcmcia stuff broke already in the 2.4.3-ac series at 9 or 10. At that point, I was to busy reporting it :-( Doing new kernels on my notebook is kind of low priority... I had the impression that either the rwsem or the pnpbios stuff was involved. As I said, I did not follow up at that time.

Martin

Signature · 5 lines
------------------------------------------------------------------
Martin Knoblauch         |    email:  [email protected]
TeraPort GmbH            |    Phone:  +49-89-510857-309
IT Services              |    Fax:    +49-89-510857-111
http://www.teraport.de   |    Mobile: +49-170-4904759

begin:vcard
n:Knoblauch;Martin
tel;cell:+49-170-4904759 tel;fax:+49-89-510857-111 tel;work:+49-89-510857-309
x-mozilla-html:FALSE
url:http://www.teraport.de
org:TeraPort GmbH;IT-Services
adr:;;Garmischer Straße 4;München;Bayern;D-80339;Germany version:2.1 email;internet:[email protected] title:Senior System Engineer x-mozilla-cpt:;32160
fn:Martin Knoblauch
end:vcard

#3 lore raw
In reply to Alan Cox
Quoted 7 lines · Alan Cox
Quoted 5 lines

my DE-620 pccard stopped working after upgrading the kernel from
2.4.3-ac7 to 2.4.4. This is on a Toshiba 4080XCDT. I used the "good" .config from the 2.4.3-ac7 build to do a make "oldconfig". The symptoms at startup are:

2.4.4 has older pcmcia than 2.4.3-ac7. It might be that. Does 2.4.4-ac work ?

just some additional info. The card actually stopped working in
2.4.3-a11 upwards with the same symptoms as in my original request.

2.4.3-ac9 is the last working one. Not sure about -ac10, because that
one crashes during boot (not related to pcmcia as far as I can remember). So, what was added in ac11 or ac10 that could hurt pcmcia or the i82365 module?

I'll now try 2.4.4-ac4.

Martin

Signature · 5 lines
------------------------------------------------------------------
Martin Knoblauch         |    email:  [email protected]
TeraPort GmbH            |    Phone:  +49-89-510857-309
IT Services              |    Fax:    +49-89-510857-111
http://www.teraport.de   |    Mobile: +49-170-4904759

begin:vcard
n:Knoblauch;Martin
tel;cell:+49-170-4904759 tel;fax:+49-89-510857-111 tel;work:+49-89-510857-309
x-mozilla-html:FALSE
url:http://www.teraport.de
org:TeraPort GmbH;IT-Services
adr:;;Garmischer Straße 4;München;Bayern;D-80339;Germany version:2.1 email;internet:[email protected] title:Senior System Engineer x-mozilla-cpt:;32160
fn:Martin Knoblauch
end:vcard

#4 lore raw
In reply to Alan Cox
Quoted 13 lines · Martin.Knoblauch
Quoted 7 lines · Alan Cox
Quoted 5 lines

my DE-620 pccard stopped working after upgrading the kernel from
2.4.3-ac7 to 2.4.4. This is on a Toshiba 4080XCDT. I used the "good" .config from the 2.4.3-ac7 build to do a make "oldconfig". The symptoms at startup are:

2.4.4 has older pcmcia than 2.4.3-ac7. It might be that. Does 2.4.4-ac work ?

just some additional info. The card actually stopped working in
2.4.3-a11 upwards with the same symptoms as in my original request.

Quoted 7 lines

2.4.3-ac9 is the last working one. Not sure about -ac10, because that
one crashes during boot (not related to pcmcia as far as I can remember). So, what was added in ac11 or ac10 that could hurt pcmcia or the i82365 module?

I'll now try 2.4.4-ac4.

done. Unfortunatelly, it fails with the same symptoms as posted
initially.

Thanks
Martin

Signature · 5 lines
------------------------------------------------------------------
Martin Knoblauch         |    email:  [email protected]
TeraPort GmbH            |    Phone:  +49-89-510857-309
IT Services              |    Fax:    +49-89-510857-111
http://www.teraport.de   |    Mobile: +49-170-4904759

begin:vcard
n:Knoblauch;Martin
tel;cell:+49-170-4904759 tel;fax:+49-89-510857-111 tel;work:+49-89-510857-309
x-mozilla-html:FALSE
url:http://www.teraport.de
org:TeraPort GmbH;IT-Services
adr:;;Garmischer Straße 4;München;Bayern;D-80339;Germany version:2.1 email;internet:[email protected] title:Senior System Engineer x-mozilla-cpt:;32160
fn:Martin Knoblauch
end:vcard

#5 lore raw
In reply to Alan Cox
Quoted 7 lines · Alan Cox
Quoted 5 lines

my DE-620 pccard stopped working after upgrading the kernel from
2.4.3-ac7 to 2.4.4. This is on a Toshiba 4080XCDT. I used the "good" .config from the 2.4.3-ac7 build to do a make "oldconfig". The symptoms at startup are:

2.4.4 has older pcmcia than 2.4.3-ac7. It might be that. Does 2.4.4-ac work ?

Hi,

after some experimenting, I found a solution that works for me. Looking
at the README-2.4 file for the pcmcia-cs package, I found that there is a strong advice AGAINST using the i82365 module when runnung 2.4.x kernels. Instead yenta_sockets should be specified. I changed that and guess what - pcmcia is working again for me.

I am not sure whether this should be closed alltogether. Maybe i82365
was not the proper choice for my hardware in the first place. Anyway, the module seems to be retired as of 2.4.3-ac10/ac11. Maybe a hint should go into the changes document.

Thanks for the patience
Martin

Signature · 5 lines
------------------------------------------------------------------
Martin Knoblauch         |    email:  [email protected]
TeraPort GmbH            |    Phone:  +49-89-510857-309
IT Services              |    Fax:    +49-89-510857-111
http://www.teraport.de   |    Mobile: +49-170-4904759

begin:vcard
n:Knoblauch;Martin
tel;cell:+49-170-4904759 tel;fax:+49-89-510857-111 tel;work:+49-89-510857-309
x-mozilla-html:FALSE
url:http://www.teraport.de
org:TeraPort GmbH;IT-Services
adr:;;Garmischer Straße 4;München;Bayern;D-80339;Germany version:2.1 email;internet:[email protected] title:Senior System Engineer x-mozilla-cpt:;32160
fn:Martin Knoblauch
end:vcard

#6 lore raw
Quoted 5 lines · [email protected] said:

I am not sure whether this should be closed alltogether. Maybe
i82365 was not the proper choice for my hardware in the first place. Anyway, the module seems to be retired as of 2.4.3-ac10/ac11. Maybe a hint should go into the changes document.

i82365 is for use only on PCMCIA bridges, not CardBus. It should not be 'retired' but should probably have the config option renamed to prevent confusion.

--
dwmw2

#7 lore raw
In reply to Martin.Knoblauch
Quoted 12 lines · David Woodhouse
Quoted 5 lines · [email protected] said:

I am not sure whether this should be closed alltogether. Maybe
i82365 was not the proper choice for my hardware in the first place. Anyway, the module seems to be retired as of 2.4.3-ac10/ac11. Maybe a hint should go into the changes document.

i82365 is for use only on PCMCIA bridges, not CardBus. It should not be 'retired' but should probably have the config option renamed to prevent confusion.

good idea. maybe the token "bridge" should appear in both the Cardbus
and PCMCIA case. It *may* have brought me on track a bit earlier :-)

It was also confusing, that the i82365 module worked [for me]
until/including 2.4.3-ac9.

Anyway, the story just shows that reading the docs helps from time to
time. :-)

Martin

Signature · 5 lines
------------------------------------------------------------------
Martin Knoblauch         |    email:  [email protected]
TeraPort GmbH            |    Phone:  +49-89-510857-309
IT Services              |    Fax:    +49-89-510857-111
http://www.teraport.de   |    Mobile: +49-170-4904759

begin:vcard
n:Knoblauch;Martin
tel;cell:+49-170-4904759 tel;fax:+49-89-510857-111 tel;work:+49-89-510857-309
x-mozilla-html:FALSE
url:http://www.teraport.de
org:TeraPort GmbH;IT-Services
adr:;;Garmischer Straße 4;München;Bayern;D-80339;Germany version:2.1 email;internet:[email protected] title:Senior System Engineer x-mozilla-cpt:;32160
fn:Martin Knoblauch
end:vcard