ATAPI Tape Driver Failure in Kernel 2.4.4
Hi,
I just upgraded from kernel 2.2.17 to 2.4.4. I use a Seagate ATAPI tape drive, model STT20000A. I use dump to do backups (probably not relevant).
In version 2.2.17 kernel, backups worked fine. In 2.4.4, I get the following error message:
ide-tape: bh == NULL in idetape_copy_stage_to_user.
Anyone know what causes this problem?
Please reply directly, as I'm not a member of this list.
Thanks :-)
Mark Bratcher
begin:vcard
n:Bratcher;Mark
tel;fax:716/288-4604
tel;work:716/288-7220
x-mozilla-html:FALSE
url:www.tpr.com
org:Torrey Pines Research
version:2.1
email;internet:[email protected]
title:Director of Software Development
adr;quoted-printable:;;565 Blossom Road=0D=0ASuite A;Rochester;New York;14610;USA x-mozilla-cpt:;19472
fn:Bratcher, Mark
end:vcard
ATAPI Tape Driver Failure in Kernel 2.4.4, More
Hi,
I just upgraded from kernel 2.2.17 to 2.4.4. I use a Seagate ATAPI tape drive, model STT20000A. I use dump to do backups (probably not relevant).
I have more data regarding tape backup failures. Here is what I get:
* In a full tape dump of about 50MB or so, everything goes smoothly. No errors.
* In a full tape dump of a little over 1GB (to a 10GB tape), I get the following errors
immediately after the backup completes and I try to write a file mark with "mt":
May 9 16:50:49 isaiah kernel: ide-tape: Reached idetape_chrdev_open
May 9 16:52:05 isaiah kernel: hdd: irq timeout: status=0xd0 { Busy }
May 9 16:52:05 isaiah kernel: hdd: ATAPI reset complete
May 9 16:52:05 isaiah kernel: ide-tape: Couldn't write a filemark
May 9 16:52:06 isaiah kernel: ide-tape: Reached idetape_chrdev_open
May 9 16:54:06 isaiah kernel: ide-tape: ht0: DSC timeout
May 9 16:54:06 isaiah kernel: hdd: ATAPI reset complete
May 9 16:54:06 isaiah kernel: ide-tape: ht0: I/O error, pc = 10, key = 2, asc
= 4,
ascq = 1
May 9 16:54:06 isaiah kernel: ide-tape: ht0: I/O error, pc = 34, key = 2, asc= 4,
ascq = 1
* In a full tape dump of between 6GB and 7GB, the backup completes, I successfully write a tape file mark with "mt", rewind, then attempt to compare. I get:
May 9 04:21:18 isaiah kernel: ide-tape: Reached idetape_chrdev_open May 9 04:22:35 isaiah kernel: ide-tape: bh == NULL in idetape_copy_stage_to_user May 9 04:22:35 isaiah kernel: ide-tape: bh == NULL in idetape_copy_stage_to_user May 9 04:22:36 isaiah kernel: ide-tape: Reached idetape_chrdev_open
The errors are repeatable and do not occur in 2.2.17. At this rate, I'll have to go back to 2.2.17 to get successful backup scripts working.
Anyone know what causes this problem?
Please reply directly, as I'm not a member of this list.
Thanks :-)
Mark Bratcher
begin:vcard
n:Bratcher;Mark
tel;fax:716/288-4604
tel;work:716/288-7220
x-mozilla-html:FALSE
url:www.tpr.com
org:Torrey Pines Research
version:2.1
email;internet:[email protected]
title:Director of Software Development
adr;quoted-printable:;;565 Blossom Road=0D=0ASuite A;Rochester;New York;14610;USA x-mozilla-cpt:;19472
fn:Bratcher, Mark
end:vcard
Re: ATAPI Tape Driver Failure in Kernel 2.4.4, More
In reply to Mark BratcherUse SCSI emulation instead of ATAPI for the tape device. Also make sure your mt is >= 0.5.
[tim@abit tim]# mt -v
mt-st v. 0.5b
[tim@abit linux]# dump -v
dump 0.4b
[tim@abit linux]# restore -v
restore 0.4b17
[dmesg exerpts - tape is /dev/st0]
...
hdd: HP COLORADO 20GB, ATAPI TAPE drive
...
scsi0 : SCSI host adapter emulation for IDE ATAPI devices scsi : 1 host.
Vendor: HP Model: COLORADO 20GB Rev: 4.01
Type: Sequential-Access ANSI SCSI revision: 02
Detected scsi tape st0 at scsi0, channel 0, id 0, lun 0
...
for 2.2.x .config:
CONFIG_BLK_DEV_IDESCSI
#CONFIG_BLK_DEV_IDETAPECONFIG_SCSICONFIG_CHR_DEV_ST
Quoted 10 lines
immediately after the backup completes and I try to write a file mark with "mt":
May 9 16:50:49 isaiah kernel: ide-tape: Reached idetape_chrdev_open May 9 16:52:05 isaiah kernel: hdd: irq timeout: status=0xd0 { Busy } May 9 16:52:05 isaiah kernel: hdd: ATAPI reset complete May 9 16:52:05 isaiah kernel: ide-tape: Couldn't write a filemark May 9 16:52:06 isaiah kernel: ide-tape: Reached idetape_chrdev_open May 9 16:54:06 isaiah kernel: ide-tape: ht0: DSC timeout May 9 16:54:06 isaiah kernel: hdd: ATAPI reset complete...
Signature · 1 line
| 650.390.9613 | [email protected]
Re: ATAPI Tape Driver Failure in Kernel 2.4.4, More
In reply to Mark BratcherTim,
Thanks for the input.
Sadly, it didn't work. I tried the SCSI emulation (which I already had running on the CD-ROM, which works), but it fails for the tape.
With SCSI emulation turned on, the system recognizes the tape drive as SCSI. However, an attempt at the following command:
mt -f /dev/st0 rewind
yields the following errors:
May 10 07:49:33 isaiah kernel: st0: Error with sense data: [valid=0] Info fld=0x0, Current st09:00: sense key Illegal Request May 10 07:49:33 isaiah kernel: Additional sense indicates Invalid command
operation code
This all works OK in kernel 2.2.17. But it fails in 2.4.4.
Mark
Quoted 40 lines · Tim Moore
Use SCSI emulation instead of ATAPI for the tape device. Also make sure your mt is >= 0.5.
[tim@abit tim]# mt -v
mt-st v. 0.5b
[tim@abit linux]# dump -v
dump 0.4b
[tim@abit linux]# restore -v
restore 0.4b17[dmesg exerpts - tape is
/dev/st0]
...
hdd: HP COLORADO 20GB, ATAPI TAPE drive
...
scsi0 : SCSI host adapter emulation for IDE ATAPI devices scsi : 1 host.
Vendor: HP Model: COLORADO 20GB Rev: 4.01
Type: Sequential-Access ANSI SCSI revision: 02
Detected scsi tape st0 at scsi0, channel 0, id 0, lun 0
...for 2.2.x .config:
CONFIG_BLK_DEV_IDESCSI
#CONFIG_BLK_DEV_IDETAPECONFIG_SCSICONFIG_CHR_DEV_STQuoted 10 lines
immediately after the backup completes and I try to write a file mark with "mt":
May 9 16:50:49 isaiah kernel: ide-tape: Reached idetape_chrdev_open May 9 16:52:05 isaiah kernel: hdd: irq timeout: status=0xd0 { Busy } May 9 16:52:05 isaiah kernel: hdd: ATAPI reset complete May 9 16:52:05 isaiah kernel: ide-tape: Couldn't write a filemark May 9 16:52:06 isaiah kernel: ide-tape: Reached idetape_chrdev_open May 9 16:54:06 isaiah kernel: ide-tape: ht0: DSC timeout May 9 16:54:06 isaiah kernel: hdd: ATAPI reset complete...
Quoted 7 lines
--
| 650.390.9613 | [email protected]
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
begin:vcard
n:Bratcher;Mark
tel;fax:716/288-4604
tel;work:716/288-7220
x-mozilla-html:FALSE
url:www.tpr.com
org:Torrey Pines Research
version:2.1
email;internet:[email protected]
title:Director of Software Development
adr;quoted-printable:;;565 Blossom Road=0D=0ASuite A;Rochester;New York;14610;USA x-mozilla-cpt:;19472
fn:Bratcher, Mark
end:vcard
Re: ATAPI Tape Driver Failure in Kernel 2.4.4, More
In reply to Mark BratcherQuoted 3 lines · Mark Bratcher
This all works OK in kernel 2.2.17. But it fails in 2.4.4.
Quoted 1 line
hdd: HP COLORADO 20GB, ATAPI TAPE drive
I did my own playing with 2.4.x on the 14gb model of this tape drive, all i've managed to do is be able to write to the tape, but not read from it. Even in 2.2.x, putting the IDE patches in, breaks it. Apparently the HP's aren't completely ATAPI compatible
Re: ATAPI Tape Driver Failure in Kernel 2.4.4, More
In reply to Mark BratcherQuoted 9 lines · Mike Dresser
Quoted 3 lines · Mark Bratcher
This all works OK in kernel 2.2.17. But it fails in 2.4.4.
Quoted 1 line
hdd: HP COLORADO 20GB, ATAPI TAPE drive
I did my own playing with 2.4.x on the 14gb model of this tape drive, all i've managed to do is be able to write to the tape, but not read from it. Even in 2.2.x, putting the IDE patches in, breaks it. Apparently the HP's aren't completely ATAPI compatible
I can write my HP 20GB drive with ide-tape. For restores I use ide-scsi. Its a bit of a hack but does work around the problem.
Ed Tomlinson <[email protected]>
Re: ATAPI Tape Driver Failure in Kernel 2.4.4, More
In reply to Mark BratcherQuoted 3 lines
Quoted 3 lines
to do is be able to write to the tape, but not read from it. Even in 2.2.x, putting the IDE patches in, breaks it. Apparently the HP's aren't completely ATAPI compatible
scsi0 : SCSI host adapter emulation for IDE ATAPI devices scsi : 1 host.
Vendor: HP Model: COLORADO 20GB Rev: 4.01
Type: Sequential-Access ANSI SCSI revision: 02
Detected scsi tape st0 at scsi0, channel 0, id 0, lun 0
The following all work with the above, either ide.2.2.19.04092001.patch or ide.2.2.18.1221.patch:
linux-2.2.19pre17-ide
linux-2.2.19-intel-hpt-smp
linux-2.2.19-amd-via-ide
linux-2.2.20p2-amd-via-ide
[14:17] abit:/etc/dump > more *.block
::::::::::::::
dump0-abit-2.2.19-050401-06:43:36.block
::::::::::::::
/ 0 dump /usr 90113 dump /var 3593378 dump /tmp 3675075 dump /home 3692644 dump /kits 5237605 dump /big 9440550 dump :::::::::::::: dump1-abit-2.2.20-050901-17:10:08.block :::::::::::::: / 14567911 dump /usr 14574120 dump /var 14810569 dump /tmp 14832970 dump /home 14833227 dump /kits 15199116 dump /big 15850029 dump
[14:17] abit:/etc/dump > mt seek 14567911
[14:18] abit:/etc/dump > mt tell
At block 14567911.
[14:20] abit:/etc/dump > /sbin/restore -t -f /dev/nst0 | head Level 1 dump of / on abit:/dev/hda2
Label: "abit-2.2.20"
Dump date: Wed May 9 17:11:53 2001
Dumped from: Fri May 4 06:43:36 2001
2 .
11 ./lost+found
4065 ./lost+found/#4065
4019 ./dev
4030 ./dev/initctl
4083 ./dev/audio
4084 ./dev/audio1
4111 ./dev/consolergds,
tim.
--