Skip to contentSkip to conversation

Question about cfi_cmdset_0001.c

DISCUSSION Stefan Thomasson 2 participants 2 messages Aug 23, 2001 – Aug 24, 2001 Memory technology devices (MTD)

lore
Share & tools
lore
#0 lore raw

Hello,

I have discovered some problems with the strataflash memory and resets on our board (strongarm assabet clone),
and after looking in this file I discovered that after erasing and writing, the
state of the chips are left in FL_STATUS.

Which in our case results in the status is output after reset if it happens before any reads from flash.

Is there a reason not to enter read array mode / FL_READY.

Best regards

Stefan Thomasson

#1 lore raw
Quoted 2 lines · [email protected] said:

I have discovered some problems with the strataflash memory and resets
on our board (strongarm assabet clone),

You cloned an Assabet - and you didn't fix the fact that in a fit of stupidity they didn't bother to connect the reset line to the flash chips?

I have no sympathy for you :)

Yes, we could make the flash drivers leave the chips in state FL_READY more often. No, it wouldn't make it robust - only slightly less likely to break.

--
dwmw2