Skip to contentSkip to conversation

how to display manually set proxy ARP entries with iproute2?

DISCUSSION Christopher Friesen 1 participant 1 message Sep 18, 2001

lore
Share & tools
lore
#0 lore raw

This issue was posted on the netdev list a while back and got no answer.

I'm quoting the original post here:

Quoted 15 lines · Lutz Pressler

Hello,

I am not able to get information about manually set proxy ARP entries with the "ip" tool (iproute2-ss010824), tested on both 2.2.19 and 2.4.8-ac7 kernels.

# ip neigh add proxy 172.20.1.1 dev eth0

The "arp" tool then yields (normal entries trimmed)

# arp -n
Address              HWtype  HWaddress           Flags Mask        Iface
192.168.1.254        ether   00:80:C8:F6:47:6F   C                 eth0
172.20.1.1           *       *                   MP                eth0
Quoted 5 lines

but "ip" only shows

# ip neigh show
192.168.1.254 dev eth0 lladdr 00:80:c8:f6:47:6f nud reachable

Is this expected behaviour or a (kernel) bug?

I'd like to know about this as well, since this is the only reason why I keep the "arp" command around.

Chris

Signature · 4 lines
Chris Friesen                    | MailStop: 043/33/F10  
Nortel Networks                  | work: (613) 765-0557
3500 Carling Avenue              | fax:  (613) 765-2986
Nepean, ON K2H 8E9 Canada        | email: [email protected]