Skip to contentSkip to conversation

PROBLEM: AST P/75 causes Machine Check Exception type 0x9 on v2.4.10

DISCUSSION Daniel Elvin 2 participants 3 messages Sep 29, 2001

lore
Share & tools
lore
#0 lore raw

Summary
Booting an AST Bravo P/75 with kernel v2.4.10 results in a "CPU#0 Machine Check Exception: 0x10C938 (type: 0x9)".

Description
The AST Bravo P/75
<http://www.ari-service.com/support/summary.asp?pn=501701-411&x=26&y=12>
boots fine on a v2.2.19pre17-kernel but both v2.4.10 and v2.4.9 causes the Machine Check Exception-error with either of the config options M586TSC, M586, or M386 set. A TB from AST
<http://www.ari-service.com/bulletin/TB/1641TB.HTM> reports a problem with parity checking using Netware on a number of AST Pentium computers, caused by the cache parity bit connector to the Pentium processor isn't connected to the cache. I have not found any information if this is also the case of the Bravo P/75.

Keywords
2.4.10, Machine Check Exception, AST Bravo P/75.

Regards,
Daniel Elvin

=========================================
Daniel Elvin [email protected]
=========================================
Flojtvagen 8B phone: +46 708 159351
SE-224 68 Lund
Sweden

#1 lore raw
Quoted 2 lines

Booting an AST Bravo P/75 with kernel v2.4.10 results in a "CPU#0 Machine Check Exception: 0x10C938 (type: 0x9)".

Please try 2.4.9ac17 - it should be fixed in the -ac tree, and if so I can push it on to Linus

Alan

#2 lore raw
Quoted 5 lines
Quoted 2 lines

Booting an AST Bravo P/75 with kernel v2.4.10 results in a "CPU#0 Machine Check Exception: 0x10C938 (type: 0x9)".

Please try 2.4.9ac17 - it should be fixed in the -ac tree, and if so I can push it on to Linus

That solved the problem. Thanks!

/Daniel