Skip to contentSkip to conversation

scsi acard AEC6712D and atp870u.c driver

DISCUSSION Sam 1 participant 1 message Dec 22, 2001

lore
Share & tools
lore

Sam

author
#0 lore raw

*please cc the answers to me*

hello

i am using an acer scanwit scanner which comes with the acard AEC6712D scsi controller.
i am also using the acard driver in 2.4.7 (also tried 2.4.13). ejecting the scanner seems to work (no data sent), but scanning and previewing seems to cause problems.

it seems to be the driver that is causing the problems. when it eventually times out, i get:

scsi : aborting command due to timeout : pid 0, scsi0, channel 0, id 0, lun 0 Write (10) 00 82 00 00 01 00 1d e2 00
working=1 last_cmd=0 quhdu=1a quendu=1a r 0= a r 1=2c r 2=cf r 3=2a r 4= 0 r 5=82 r 6= 0 r 7= 0 r 8= 1 r 9= 0 r a=1d r b=e2 r c= 0 r d= 0 r e= 0 r f= 0 r10=3a r11=20 r12= 0 r13= 0 r14= 2 r15=20 r16=80 r1c= 0 r1f=35 in_snd= 0 r20= 1 r22= 8 r3a=2b r3b=20

que cdb= 2a 0 82 0 0 1 0 1d e2 0 last_lenu= 1de2

i have gotten some suggestions such as

removing

     if (dev->ata_cdbu[0] == READ_CAPACITY) {
       if (workrequ->request_bufflen > 8) {
               workrequ->request_bufflen = 0x08;
       }
     }

from the driver code, but this just causes the target id (as seen above to be: 0) to be the last command so the command it got before was 0xff

as seen from
if ((j & 0x40) != 0)

		{
		     if (dev->last_cmd == 0xff)
		     {
			dev->last_cmd = target_id;
		     }
		     dev->last_cmd |= 0x40;
		}

any ideas on what the problem might be? when was the lastest bug update on atp870u.c?

thanx,

*please cc the answers to me*

--sam