Strange: load=stable, running idle=unstable

Hi,

I recently had problems with 2 eepro100 cards in my system. I could crash the kernel (only reboot helped) if I copied a 700 MB file to the server. It crashed after 100 MB or so.

I experimented a bit with the intel eepro drivers, the kernel drivers as a loadable module, compiled in etc, but it all didn't make much difference.

I had the most problems with 2.4.17 (vanilla). The most stable kernel seemed to be 2.4.15pre5.

I found out that the kernel stays absolutely stable if it is under load. I first tried compiling a kernel non stop for 3 days in a loop. System was absolutely stable.

I switched from non-stop compiling to running setiathome. Also makes the kernel run beautifully.

But as soon as the kenel is doing nothing except light routing of the 768/128kbit DSL into the 100 MBit LAN and mainly running idle, as soon as you try and copy a large file via SMB - kaboom - kernel crashes.

Hardware: Soyo BX Dual PII motherboard with a single PII 266. 2 IDE HDDs (Maxtor) and a ATI PCI graphics card (no framebuffer or so compiled in, and no X, it is a server). SMB support is not compiled in, neither is any form of power management.

I thought this may be interesting to some people.