Skip to contentSkip to conversation

odd issue with sending to broadcast address

DISCUSSION Chris Friesen 1 participant 1 message Feb 18, 2002

lore
Share & tools
lore
#0 lore raw

It appears that there has been a change in the handling of sending packets to the broadcast IP address between 2.2 and 2.4.

I have an embedded system that has only local LAN access, no default route to the net as a whole. We're running 2.2.17 currently, and we use bootpc to configure the system.

We're now looking at converting to 2.4 and are running into a problem with bootpc getting "Network is unreachable" errors.

After some digging, it appears to be due to the fact that I don't have a default route specified, but this is on purpose.

strace shows that bootpc is trying to run sendto() with a destination of 255.255.255.255, and this works fine on 2.2 and fails on 2.4. Is this the desired 2.4 behaviour?

What is the appropriate configuration for my setup? Do I just add a route to 255.255.255.255? Can I set it up to broadcast out all devices automatically, or do I need to do explicit failover management? Should I be looking to fix bootpc instead?

Thanks,

Chris

Signature · 4 lines
Chris Friesen                    | MailStop: 043/33/F10  
Nortel Networks                  | work: (613) 765-0557
3500 Carling Avenue              | fax:  (613) 765-2986
Nepean, ON K2H 8E9 Canada        | email: [email protected]