Problem booting Linux on MPC8XXFADS
Quoted 11 lines · In message <[email protected]> you wrote:
Quoted 8 lines
Check that you have configured the console on the correct port; you should be able to get a good configuration with
$ make FADS860_config $ make oldconfig $ make dep $ make pImageThanks for that hint. With your sources (linux-2.4.4-2002-03-21.tar.bz2) and the configuration it works! Now i try to port that to 2.4.17
Fine.
Quoted 1 line
(possible? :-).
Better use 2_4_devel ...
Quoted 5 lines
Quoted 2 lines
But you should be aware - your chances to succesfully run Linux on a FADS rev ENG or PILOT board are pretty limted anyway.
What exactly do you mean with "be aware of"? Are there any common failures with that board? Unfortunately, i have to use this Board :-(
The (F)ADS8xx is (in)famous. Maybe it was sponsered by the
unemployment office to keep all these programmers busy, hunting for software problems for weeks and weeks and weeks (util they realized they had hardware problems).
You don't have to use this board.
There are alternative solutions. Just divide the price for another board (stable hardware with full Linux support) by your hourly rate and you probably already now wasted money on the FADS...
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] No journaling file system can recover your data if the disk dies.
- Steve Rago in <[email protected]>
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/