rtlinux interrupt response
hi all,
i have downloaded denx rtlinux and ported it to my custom board for study purpose.
my board is based on MPC860. rtlinux is working fine.
i tried to measure the interrupt response time.
i am getting best case is 30microseconds and worst case is 150microsenconds.
couldn't understand why this much difference.
can anybody explain? or is there any thing wrong in my port?
thanks
srinivas
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 6 lines · srinivas pulipati
hi all,
i have downloaded denx rtlinux and ported it to my custom board for study purpose.
my board is based on MPC860. rtlinux is working fine.
This is off topic here. Very likely you get better help from the rtlinux.org or rtai.org mailing lists.
Quoted 8 lines
i tried to measure the interrupt response time.
i am getting best case is 30microseconds and worst case is 150microsenconds.
couldn't understand why this much difference.
can anybody explain? or is there any thing wrong in my port?
With RTAI I measured sometime ago on a TQM860L, 50MHz, 8KB data cache:
Min Max Average:
No load : 13us 46us 14us
while : ; do a=a ; done: 13us 46us 18us
ping -f to target : 13us 46us 19us
If I remember correctly, rtlinux has bigger overhead (more code).
BTW: Denx has dropped support for rtlinux quite a while ago because of fsmlabs license policy (AFAIK, there is no open rtlinux for the MPC 8xx).
Hope it helps,
Wolfgang.
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/