I need help getting pcmcia working with a FADS board

Hi everyone,

I need help getting pcmcia working with a FADS board.

Did someone finish the driver?
If Yes, would you mind to share it with me?

Jacky

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

Hi Jacky,

Matthew provided me with a patch for getting the pcmcia working. I still have not enough time to test that patch. Here it goes:

Regards,

Sven

diff -Naur linuxppc_2_4_devel.org/drivers/pcmcia/Config.in linuxppc_2_4_devel/drivers/pcmcia/Config.in
@@ -25,5 +25,6 @@
    fi
 fi
 dep_tristate '  SA1100 support' CONFIG_PCMCIA_SA1100 $CONFIG_ARCH_SA1100 $CONFIG_PCMCIA
+dep_tristate '  m8xx support'  CONFIG_PCMCIA_M8XX $CONFIG_8xx $CONFIG_PCMCIA
 
 endmenu

diff -Naur linuxppc_2_4_devel.org/drivers/pcmcia/Makefile linuxppc_2_4_devel/drivers/pcmcia/Makefile
@@ -60,6 +60,7 @@
 endif
 
 obj-$(CONFIG_PCMCIA_SA1100)	+= sa1100_cs.o
+obj-$)CONFIG_PCMCIA_M8XX)	+= m8xx_pcmcia.o
 
 sa1100_cs-objs-y				:= sa1100_generic.o
 sa1100_cs-objs-$(CONFIG_SA1100_ADSBITSY)	+= sa1100_adsbitsy.o sa1111_generic.o

Sven,

Thanks ^_^
I will test it ASAP .

Is it work with kernel 2.4.19pre6 patch?
BTW, if it work with pcmcia-cs 3.1.33?

Jacky

-----Original Message-----
From: [email protected] [mailto:[email protected]]On Behalf Of Sven Boehringer
Sent: Tuesday, April 23, 2002 2:26 PM
To: Jacky Wang
Cc: May Ling List
Subject: Re: I need help getting pcmcia working with a FADS board

Hi Jacky,

Matthew provided me with a patch for getting the pcmcia working. I still have not enough time to test that patch. Here it goes:

Regards,

Sven

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

Sven,

what does it patch for?
which kernel source?
or which pcmcia-cs source?

Jacky

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/