Skip to contentSkip to conversation

ide-floppy problem - 2.4.19-pre10

DISCUSSION Emre Tezel 1 participant 1 message Jun 22, 2002

lore
Share & tools
lore

Emre Tezel

author
#0 lore raw

Dear Kernel Hackers,

I am running kernel 2.4.19-pre10. I am experiencing a problem with my internal ATAPI Zip 100 Drive. Currently I am using the ide-floppy driver. The device is attached to my secondry slave (/dev/hdd). Whenever I try to do any I/O, my system eventually comes to a full stop. I managed to extract the following kernel log messages.

Jun 21 01:17:09 hori kernel: ide-scsi: CoD != 0 in idescsi_pc_intr
Jun 21 01:17:09 hori kernel: hdd: ATAPI reset complete
Jun 21 01:17:09 hori kernel: hdd: lost interrupt
Jun 21 01:17:09 hori kernel: ide-scsi: CoD != 0 in idescsi_pc_intr
Jun 21 01:17:09 hori kernel: hdd: ATAPI reset complete
Jun 21 01:17:11 hori kernel: hdd: lost interrupt
Jun 21 01:17:11 hori kernel: ide-scsi: CoD != 0 in idescsi_pc_intr
Jun 21 01:17:11 hori kernel: scsi : aborting command due to timeout : pid 4498, scsi0, channel 0, id 0, lun 0 Write (10) 00 00 00 00 df 00 00 07 00
Jun 21 01:17:11 hori kernel: SCSI host 0 abort (pid 4498) timed out - resetting
Jun 21 01:17:11 hori kernel: SCSI bus is being reset for host 0 channel 0.
Jun 21 01:17:11 hori kernel: scsi : aborting command due to timeout : pid 4499, scsi0, channel 0, id 0, lun 0 Write (10) 00 00 00 01 04 00 00 03 00
Jun 21 01:17:11 hori kernel: SCSI host 0 abort (pid 4499) timed out - resetting
Jun 21 01:17:11 hori kernel: SCSI bus is being reset for host 0 channel 0.
Jun 21 01:17:11 hori kernel: hdd: ATAPI reset complete
Jun 21 01:17:11 hori kernel: hdd: lost interrupt
Jun 21 01:17:11 hori kernel: ide-scsi: CoD != 0 in idescsi_pc_intr
Jun 21 01:17:11 hori kernel: hdd: ATAPI reset complete
Jun 21 01:17:11 hori kernel: hdd: lost interrupt
Jun 22 02:18:04 hori syslogd 1.4.1: restart.

These messages keep repeating itself until forever.

I also tried to use the ide-scsi driver instead, but I am running into the same problem. Is this a known bug in the latest stable kernel or am I having a bad hardware ?

Thank You,
Emre