Promise Ultra 100 TX2 IDE cards provoce system crash
Promise TX2 IDE cards and PDC20268 driver: Last night when backup writing started from our Software RAID5 to the single drive, the system crashed, no oops messages.
I built up a Debian stable fileserver with Software RAID5 and Reiserfs. we use:
2 Promise Ultra 100 TX2 IDE Controller Cards,
4 Maxtor D740X ATA 133 80 GB harddisks, linked by Ultra ATA cables to the two Promise cards. Every disk is master. We use 3 disks for the Software RAID-5, one as a single (no raid) backup drive.
Kernel is 2.4.18 with Support for RAID-5, Reiserfs, Promise Ultra 100 and Server Works OSB4 IDE Controllers (the onboard controller only for a unused spare disk and cdrom). Didn't found this fixed in 2.4.19.
The system crashed during the backup from RAID to /dev/hde while writing a huge file bigger than 770 MB. This is the last log I have.
Before this crash I had another crash because of setting the drives to udma6. Now the drives are set with hdparm to udma5:
hdparm -d 1 -c 1 -k 1 -X69 /dev/hde
hdparm -d 1 -c 1 -k 1 -X69 /dev/hdg
hdparm -d 1 -c 1 -k 1 -X69 /dev/hdi
hdparm -d 1 -c 1 -k 1 -X69 /dev/hdk
Because the kernel sets only /dev/hdi and /dev/hdk to udma5 even if append="ide2=ata66 ide3=ata66 ide4=ata66 ide5=ata66" or the same with ata100 is in lilo.conf.
/etc/raidtab:
--
raiddev /dev/md0
raid-level 5
nr-raid-disks 3
nr-spare-disks 0 persistent-superblock 1
parity-algorithm left-symmetric
chunk-size 32
device /dev/hdg1
raid-disk 0
device /dev/hdi1
raid-disk 1
device /dev/hdk1
raid-disk 2
--
lspci:
--
00:00.0 Host bridge: ServerWorks CNB20HE Host Bridge (rev 23) 00:00.1 PCI bridge: ServerWorks CNB20LE Host Bridge (rev 01) 00:00.2 Host bridge: ServerWorks: Unknown device 0006 (rev 01) 00:00.3 Host bridge: ServerWorks: Unknown device 0006 (rev 01) 00:05.0 SCSI storage controller: Adaptec 7899P (rev 01)
00:05.1 SCSI storage controller: Adaptec 7899P (rev 01)
00:06.0 Ethernet controller: Intel Corp. 82557 [Ethernet Pro 100] (rev 08) 00:0f.0 ISA bridge: ServerWorks OSB4 South Bridge (rev 51)
00:0f.1 IDE interface: ServerWorks OSB4 IDE Controller
00:0f.2 USB Controller: ServerWorks OSB4/CSB5 OHCI USB Controller (rev 04) 01:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G550 AGP (rev 01) 02:01.0 Unknown mass storage controller: Promise Technology, Inc. 20268 (rev 02) 02:02.0 Unknown mass storage controller: Promise Technology, Inc. 20268 (rev 02) --
part of dmesg:
--
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ServerWorks OSB4: IDE controller on PCI bus 00 dev 79 ServerWorks OSB4: chipset revision 0
ServerWorks OSB4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:pioPDC20268: IDE controller on PCI bus 02 dev 10
PDC20268: chipset revision 2
PDC20268: not 100% native mode: will probe irqs later
PDC20268: ROM enabled at 0xfebf8000
PDC20268: (U)DMA Burst Bit DISABLED Primary PCI Mode Secondary PCI Mode.
PDC20268: FORCING BURST BIT 0x50 -> 0x51 INACTIVE
ide2: BM-DMA at 0xef90-0xef97, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xef98-0xef9f, BIOS settings: hdg:pio, hdh:pioPDC20268: IDE controller on PCI bus 02 dev 08
PDC20268: chipset revision 2
PDC20268: not 100% native mode: will probe irqs later
PDC20268: ROM enabled at 0xfebf0000
PDC20268: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.
ide4: BM-DMA at 0xef60-0xef67, BIOS settings: hdi:pio, hdj:pio
ide5: BM-DMA at 0xef68-0xef6f, BIOS settings: hdk:pio, hdl:piohda: IC35L080AVVA07-0, ATA DISK drive
hdc: ATAPI-CD ROM-DRIVE-56MAX, ATAPI CD/DVD-ROM drive
hde: MAXTOR 6L080J4, ATA DISK drive
hdg: MAXTOR 6L080J4, ATA DISK drive
hdi: MAXTOR 6L080J4, ATA DISK drive
hdk: MAXTOR 6L080J4, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0xeff0-0xeff7,0xefe6 on irq 24
ide3 at 0xefa8-0xefaf,0xefe2 on irq 24
ide4 at 0xefa0-0xefa7,0xef8e on irq 22
ide5 at 0xef80-0xef87,0xef8a on irq 22
hda: 160836480 sectors (82348 MB) w/1863KiB Cache, CHS=10011/255/63, UDMA(33)
hde: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63, (U)DMA
hdg: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63, (U)DMA
hdi: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63, UDMA(100)
hdk: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63, UDMA(100)
hdc: ATAPI 50X CD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
--
part of .config (enabled options only):
--
#
# IDE, ATA and ATAPI Block devices
#CONFIG_BLK_DEV_IDE=yCONFIG_BLK_DEV_IDEDISK=yCONFIG_BLK_DEV_IDECD=yCONFIG_BLK_DEV_CMD640=yCONFIG_BLK_DEV_RZ1000=yCONFIG_BLK_DEV_IDEPCI=yCONFIG_BLK_DEV_IDEDMA_PCI=yCONFIG_BLK_DEV_ADMA=yCONFIG_IDEDMA_PCI_AUTO=yCONFIG_BLK_DEV_IDEDMA=yCONFIG_BLK_DEV_PIIX=yCONFIG_PIIX_TUNING=yCONFIG_BLK_DEV_PDC202XX=yCONFIG_PDC202XX_BURST=yCONFIG_PDC202XX_FORCE=yCONFIG_BLK_DEV_SVWKS=yCONFIG_IDEDMA_AUTO=yCONFIG_BLK_DEV_IDE_MODES=yCONFIG_BLK_DEV_ATARAID=y
--
thanks for any help!
Signature · 3 lines
Fabian Lienert . mitLinks AG . Limmatstrasse 291 . CH-8005 Zürich [email protected] . ++41 1 444 10 44 . http://www.mitlinks.ch pgp public key: http://www.mitlinks.ch/keys/lienert.asc