can't run two acenics in the same machine??
Since the e1000 keeps scribbling over my memory (it appears), I tried to tie-break with two NetGear GA 620 nics.
Well, it only finds one!!
In the meantime, I hear that tigonIII is a reasonably good performer. Anyone suggest a NIC based on this chipset that is well supported?
From dmesg:
acenic.c: v0.92 08/05/2002 Jes Sorensen, [email protected]
http://home.cern.ch/~jes/gige/acenic.html
eth2: NetGear GA620 Gigabit Ethernet at 0xf4000000, irq 10
Tigon II (Rev. 6), Firmware: 12.4.11, MAC: 00:a0:cc:73:37:3a PCI bus width: 64 bits, speed: 66MHz, latency: 64 clks Disabling PCI memory write and invalidate
eth2: Firmware NOT running!
eth2: NetGear GA620 Gigabit Ethernet at 0xf4004000, irq 9
Tigon II (Rev. 6), Firmware: 12.4.11, MAC: 00:a0:cc:73:35:d6 PCI bus width: 64 bits, speed: 66MHz, latency: 64 clks Disabling PCI memory write and invalidate
eth2: Firmware up and running
from lspci -v:
00:08.0 Ethernet controller: Netgear GA620 (rev 01)
Subsystem: Netgear: Unknown device 0001
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (16000ns min), cache line size 10
Interrupt: pin A routed to IRQ 10
Region 0: Memory at f4000000 (32-bit, non-prefetchable) [size=16K]
00:09.0 Ethernet controller: Netgear GA620 (rev 01)
Subsystem: Netgear: Unknown device 0001
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (16000ns min), cache line size 10
Interrupt: pin A routed to IRQ 9
Region 0: Memory at f4004000 (32-bit, non-prefetchable) [size=16K]
Any ideas?
Thanks,
Ben
Signature · 3 lines
Ben Greear <[email protected]> <Ben_Greear AT excite.com> President of Candela Technologies Inc http://www.candelatech.com ScryMUD: http://scry.wanfear.com http://scry.wanfear.com/~greear
I've got 4 3com 3c985 acenic based chips running in a box without any probs.
00:01.0 Ethernet controller: 3Com Corporation 3c985 1000BaseSX (rev 01)
Subsystem: Unknown device 9850:0001
Flags: bus master, 66Mhz, medium devsel, latency 96, IRQ 15
Memory at febfc000 (32-bit, non-prefetchable) [size=16K]--
01:02.0 Ethernet controller: 3Com Corporation 3c985 1000BaseSX (rev 01)
Subsystem: Unknown device 9850:0001
Flags: bus master, 66Mhz, medium devsel, latency 96, IRQ 4
Memory at efffc000 (32-bit, non-prefetchable) [size=16K]01:03.0 Ethernet controller: 3Com Corporation 3c985 1000BaseSX (rev 01)
Subsystem: Unknown device 9850:0001
Flags: bus master, 66Mhz, medium devsel, latency 96, IRQ 11
Memory at efff8000 (32-bit, non-prefetchable) [size=16K]--
02:04.0 Ethernet controller: 3Com Corporation 3c985 1000BaseSX (rev 01)
Subsystem: Unknown device 9850:0001
Flags: bus master, 66Mhz, medium devsel, latency 96, IRQ 4
Memory at edffc000 (32-bit, non-prefetchable) [size=16K]I've also got 3 tigon3 nics running in another box without any probs.
01:02.0 Ethernet controller: BROADCOM Corporation NetXtreme BCM5701 Gigabit Ethernet (rev 15)
Subsystem: 3Com Corporation 3C996-SX 1000BaseSX
Flags: bus master, 66Mhz, medium devsel, latency 96, IRQ 15
Memory at efff0000 (64-bit, non-prefetchable) [size=64K]
Capabilities: [40] #07 [0000]
Capabilities: [48] Power Management version 2
--
01:03.0 Ethernet controller: BROADCOM Corporation NetXtreme BCM5701 Gigabit Ethernet (rev 15)
Subsystem: 3Com Corporation 3C996-SX 1000BaseSX
Flags: bus master, 66Mhz, medium devsel, latency 96, IRQ 5
Memory at effe0000 (64-bit, non-prefetchable) [size=64K]
Capabilities: [40] #07 [0000]
Capabilities: [48] Power Management version 2
--
02:04.0 Ethernet controller: BROADCOM Corporation NetXtreme BCM5701 Gigabit Ethernet (rev 15)
Subsystem: 3Com Corporation 3C996-SX 1000BaseSX
Flags: bus master, 66Mhz, medium devsel, latency 96, IRQ 15
Memory at edff0000 (64-bit, non-prefetchable) [size=64K]
Capabilities: [40] #07 [0000]
Capabilities: [48] Power Management version 2
Quoted 54 lines · Ben Greear
Since the e1000 keeps scribbling over my memory (it appears), I tried to tie-break with two NetGear GA 620 nics.
Well, it only finds one!!
In the meantime, I hear that tigonIII is a reasonably good performer. Anyone suggest a NIC based on this chipset that is well supported?
From dmesg:
acenic.c: v0.92 08/05/2002 Jes Sorensen, [email protected]
http://home.cern.ch/~jes/gige/acenic.html
eth2: NetGear GA620 Gigabit Ethernet at0xf4000000, irq 10
Tigon II (Rev. 6), Firmware: 12.4.11, MAC: 00:a0:cc:73:37:3a PCI bus width: 64 bits, speed: 66MHz, latency: 64 clks Disabling PCI memory write and invalidate
eth2: Firmware NOT running!
eth2: NetGear GA620 Gigabit Ethernet at0xf4004000, irq 9
Tigon II (Rev. 6), Firmware: 12.4.11, MAC: 00:a0:cc:73:35:d6 PCI bus width: 64 bits, speed: 66MHz, latency: 64 clks Disabling PCI memory write and invalidate
eth2: Firmware up and runningfrom lspci -v:
00:08.0 Ethernet controller: Netgear GA620 (rev 01)
Subsystem: Netgear: Unknown device 0001
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (16000ns min), cache line size 10
Interrupt: pin A routed to IRQ 10
Region 0: Memory atf4000000(32-bit, non-prefetchable) [size=16K]00:09.0 Ethernet controller: Netgear GA620 (rev 01)
Subsystem: Netgear: Unknown device 0001
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (16000ns min), cache line size 10
Interrupt: pin A routed to IRQ 9
Region 0: Memory atf4004000(32-bit, non-prefetchable) [size=16K]Any ideas?
Thanks,
Ben--
Ben Greear <[email protected]> <Ben_GreearAT excite.com>
President of Candela Technologies Inc http://www.candelatech.com
ScryMUD: http://scry.wanfear.com http://scry.wanfear.com/~greear
Quoted 6 lines
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[-] Steve Mickeler [ [email protected] ]
[|] Todays root password is brought to you by /dev/random
[+] 1024D/9AA80CDF = 4103 9E35 2713 D432 924F 3C2E A7B9 A0FE 9AA8 0CDF