Skip to contentSkip to conversation

SCSI Tape hangs when no tape loaded (2.5.6x)

DISCUSSION Ruud Linders 1 participant 1 message Feb 16, 2003

lore
Share & tools
lore
#0 lore raw

Kai,

That did it !

I was running mt-st-0.5b, upgrading to 0.7 fixed the 'mt' command as well as the 'stinit' command which caused my boot to delay for 2 minutes as that was called from the boot scripts.

THanks

Quoted 26 lines · Ruud Linders
Quoted 11 lines

On both 2.5.60 and 2.5.61 when there is no tape loaded in my SCSI DAT tape drive, access to the drive blocks for exactly 2 minutes before timing out and giving an I/O error.

# mt stat
....... < 2 minutes later > ...
/dev/tape: Input/output error

Does you mt open the tape device with the O_NONBLOCK option? If not, this is what is expected. mt-st version >= 0.6 does use this option. I don't know about other mt's.

The open() behaviour of st was changed at 2.5.3 to conform with SUS (blocking) and what the other Unices do (timeout). If the device is opened without O_NONBLOCK, the driver waits for some time (default 2 minutes) for the device to become ready. If it does not become ready, an error is returned.

Kai

P.S. I just tested 2.5.61 and in my system 'mt status' without tape in the drive works as expected (i.e., prints status immediately).