Skip to contentSkip to conversation

X windows for Linux PPC embedded

DISCUSSION Jan Damborsky 2 participants 3 messages Feb 24, 2003 – Feb 26, 2003

lore
Share & tools
lore
#0 lore raw

Hello guys,

I would like to ask, if there is some project for porting X windows system to Embedded PPC Linux. I use board with MPC823E with VGA TFT display+touch screen, 32MB RWM, 4MB FLASH, Ethernet, serial RS232,....
I would like to use it as remote graphic terminal communicating via Ethernet by means of X protocol. Does somebody know how to make it work ?

HANYS

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

#1 lore raw
Quoted 9 lines · In message <[email protected]> you wrote:

I would like to ask, if there is some project for porting X windows system to Embedded PPC Linux. I use board with MPC823E with VGA TFT display+touch screen, 32MB RWM, 4MB FLASH, Ethernet, serial RS232,....
I would like to use it as remote graphic terminal communicating via Ethernet by means of X protocol. Does somebody know how to make it work ?

There is nothing much to "port". Just use a system with as much as possible RAM, and a local harddisk, so you can enable swap space, and run the standard "make" procedure on the target (native!).

I once looked into this trying to find out if you could prepare X11R6 for cross compilation, but found it too difficult / not worth the effort. I ran a build on a MPC860P with 64 MB RAM and a 20 GB harddisk attached to the PCMCIA slot. It took _ages_ (> 48 hours, IIRC) but except for some minor issues the build went through. I think this was in the age of HHL 1.2 JE, so any decent build environment should work fine, too.

Best regards,

Wolfgang Denk

--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] Hacking's just another word for nothing left to kludge.

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

#2 lore raw
Quoted 27 lines · Wolfgang Denk
Quoted 10 lines · In message <[email protected]> you wrote:

I would like to ask, if there is some project for porting X windows system to Embedded PPC Linux. I use board with MPC823E with VGA TFT display+touch screen, 32MB RWM, 4MB FLASH, Ethernet, serial RS232,....
I would like to use it as remote graphic terminal communicating via Ethernet by means of X protocol. Does somebody know how to make it work ?

There is nothing much to "port". Just use a system with as much as possible RAM, and a local harddisk, so you can enable swap space, and run the standard "make" procedure on the target (native!).

I once looked into this trying to find out if you could prepare X11R6 for cross compilation, but found it too difficult / not worth the effort. I ran a build on a MPC860P with 64 MB RAM and a 20 GB harddisk attached to the PCMCIA slot. It took _ages_ (> 48 hours, IIRC) but except for some minor issues the build went through. I think this was in the age of HHL 1.2 JE, so any decent build environment should work fine, too.

Quoted 6 lines

Best regards,

Wolfgang Denk

Thank you for information, HANYS

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/