Skip to contentSkip to conversation

Promise PDC 20376

DISCUSSION David Monniaux 3 participants 5 messages Feb 28, 2003

lore
Share & tools
lore
#0 lore raw

Is anybody (Andre?) working on a driver for the Promise PDC 20376 Serial ATA / RAID controller?

#1 lore raw
Quoted 2 lines · David Monniaux

Is anybody (Andre?) working on a driver for the Promise PDC 20376 Serial ATA / RAID controller?

Andre is not, and with his reasons I don't think anyone else will either. There is a binary module available from promise's website, if you are using an intel machine.

Signature · 2 lines
Måns Rullgård
[email protected]
#2 lore raw
In reply to David Monniaux
Quoted 2 lines · David Monniaux

Is anybody (Andre?) working on a driver for the Promise PDC 20376 Serial ATA / RAID controller?

No. The SII is supported and the HPT with SATA bridges should work. Some informal discussion has occurred with two other vendors who will be releasing SATA products in time.

It is probably possible to reverse engineer the 20376 since I suspect it will behave like the older devices but with the registers memory mapped.

#3 lore raw
Quoted 10 lines · Alan Cox
Quoted 2 lines · David Monniaux

Is anybody (Andre?) working on a driver for the Promise PDC 20376 Serial ATA / RAID controller?

No. The SII is supported and the HPT with SATA bridges should work. Some informal discussion has occurred with two other vendors who will be releasing SATA products in time.

It is probably possible to reverse engineer the 20376 since I suspect it will behave like the older devices but with the registers memory mapped.

As I suppose you already know, the 20375 driver acts like a scsi driver. I ran it through objdump -d and got ~20000 instructions. I doubt anyone would want to analyse that load, even if it were legal.

Signature · 2 lines
Måns Rullgård
[email protected]
#4 lore raw
Quoted 3 lines · Måns Rullgård

As I suppose you already know, the 20375 driver acts like a scsi driver. I ran it through objdump -d and got ~20000 instructions. I doubt anyone would want to analyse that load, even if it were legal.

Its legal here but I suspect you would get further mapping the MMIO registers and reading the contents then seeing which values make sense matched to which normal IDE registers.