Realtek 8139c - kernel 2.4.21-rc3
Hi,
Just compiled this kernel with 8139too as module. I have adsl (pppoe) connection. Problem is, connection is lost after about 2-5 minutes after start. I tested eth card with ftp://ftp.scyld.com/pub/diag/rtl8139-diag.c
and found something like this "configured with ABNORMAL settings".Or something like this. So I downloaded driver (v1.01)from www.realtek.com.tw, replaced 8139too module and now all semms to be ok.
This diag tool says now : "configured with normal settings"
Gutko
Gutko,
Quoted 3 lines · Gutko
Just compiled this kernel with 8139too as module. I have adsl (pppoe) connection. Problem is, connection is lost after about 2-5 minutes after start. I tested eth card with ftp://ftp.scyld.com/pub/diag/rtl8139-diag.c
and found something like this "configured with ABNORMAL settings".Or
Were you forcing full-duplex or 100mbps?
Quoted 2 lines
something like this. So I downloaded driver (v1.01)from www.realtek.com.tw, replaced 8139too module and now all semms to be ok.
AFAIK, the driver from www.realtek.com.tw *is* 8139too.
Quoted 1 line
This diag tool says now : "configured with normal settings"
Yep, it doesn't seem to be a driver problem, but forcing a buggy
configuration to the driver.
What probably happened is that when you downloaded the driver from
the Realtek website, the modules.conf part of this "new" driver (or some other script you might be using to load it) isn't forcing any options and letting the driver figure out the best configuration.
Kind Regards,
Felipe