Skip to contentSkip to conversation

Sanity checks and interrupts

DISCUSSION Timothy Miller 1 participant 1 message Nov 21, 2003

lore
Share & tools
lore
#0 lore raw

I'm sure there's a FAQ about this somewhere, although I have done some googling and not found much helpful info.

Anyhow, I wish I could give you more information on my computer, but I'm at work, and the computer is at home. In short, it's running RH9 with the latest up2date kernel (2.4.20-??). The motherboard is an Abit KD7 which is a KT400 MB.

How, everthing seems to work fine, but in my (very slow) research for system sanity checking, I've noticed people talking about interrupts. Well, so I dumped /proc/interrupts and looked at it.

To begin with, I notice that there are only "XT-PIC" interrupts. Why is that? From what I've read, others have "AT-PIC" and "APIC" interrupts as well. Being a modern MB, I would expect to see something else. Does that mean there's a problem?

Secondly, I noticed that both the network card (well, I have two, one built in, the other PCI, and I don't remember which) and my 3ware RAID controller (7000-2 or something) are sharing the same interrupt (11, I think), and in fact, there are two or three other devices on that same interrupt, which seems unbalanced to me. Is THAT a problem? It is, after all, only a single processor box, but could there be any kind of performance issue because of this? How about stability?

I'm typing this email on a RH7.2 box running 2.4.18-27.7.x, and I checked /proc/interrupts here as well. This is what I get:

CPU0

  0:  663851803          XT-PIC  timer
  1:     208891          XT-PIC  keyboard
  2:          0          XT-PIC  cascade
  8:          1          XT-PIC  rtc
  9:          0          XT-PIC  usb-uhci
 10:          0          XT-PIC  Intel ICH2
 11:  103158523          XT-PIC  usb-uhci, eth0, nvidia
 12:    4313520          XT-PIC  PS/2 Mouse
 14:    1245414          XT-PIC  ide0
 15:    8417399          XT-PIC  ide1
NMI:          0
ERR:          0

What decides that three devices should be on 11 but only one on 10 or 12? Why not two on each? Why isn't one on 13? I know that not all devices can have dynamically assigned interrupts.

And why is nothing hooked up to interrupts 3 thru 7? I'm sure there's some legacy issue to do with this, although if they refer to things which have been deprecated, I'm surprised modern MB's don't reassign them.

And another thing... wrt PCI devices, I know that each slot is assigned one of four interrupt lines in rotation. My MB has 6 slots, although one of them is the "you can't use this" slot for AGP. (BTW, more than 4 slots per bus is a PCI spec violation.) If my NIC is in the last slot and the 3ware is in the first, maybe they share interrupt signal lines.
Perhaps moving one of them would change things. But would that make
one iota of difference?

Thanks!