Skip to contentSkip to conversation

[2.4.23] IPv6 creates errors on my ethernet device

DISCUSSION Marcello 1 participant 1 message Nov 30, 2003

lore
Share & tools
lore

Marcello

author
#0 lore raw

Hi all ,

I have an ethernet card with a Realtek 8139C chip , and I've enabled IPv6 in my kernel (2.4.23)

My ethernet card is connected to an ADSL Modem , an Ericsson HM220dp, and every (appoximatly) 50000 packets transmitted/recived by the devices ,if IPv6 is enabled , ifconfig reports an error in RX packages :

bash-2.05b# ifconfig
eth0 Link encap:Ethernet HWaddr 00:E0:7D:D5:0C:ED

         inet6 addr: fe80::2e0:7dff:fed5:ced/64 Scope:Link
         UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
         RX packets:95734 errors:1 dropped:0 overruns:0 frame:0
         TX packets:101956 errors:0 dropped:0 overruns:0 carrier:0
         collisions:465 txqueuelen:1000
         RX bytes:24717818 (23.5 Mb)  TX bytes:52543424 (50.1 Mb)
         Interrupt:17 Base address:0x5f00

The modem is connected at 10Mbps speed Half-Duplex .

If I disable IPv6 I don't see errors on the ethernet device , I've tried until 1500000 packets without errors .

What cause those errors? The only solution is disable IPv6?? I've found this problem on 2.4.22 too (I haven't tried IPv6 on previous kernels)

Thanks

Marcello