Skip to contentSkip to conversation

RAID5 resync blocking on 2.6.0-test11

PATCH Fernando Serboncini - Campo Geral 1 participant 1 message Dec 11, 2003 MD RAID

lore
Share & tools
lore
#0 lore raw

Hi LKML,

I've just installed a software-RAID 5 on my Alpha (miata) Workstation 500au with Kernel 2.6.0-test11. The RAID is made of 4 Western Digital 250Gb HDs on a promise-ata-133tx2.

The initial raidstart and mke2fs worked fine. After the initial sync, a clean boot and a new raidstart, the /proc/mdstat reported that the drive was at "resync" (/var/log/messages says that "raid array is not clean").

The problem is, the resync was blocking the /dev/md0. So, when I did a 'mount /dev/md0', it blocked until the resync was done (and it was a looong time for a nearly 1TB RAID).

Looking through driver/md code I've realized that md_do_sync() was the real devil. After a few diffs with 2.4.23 code I've realized that at the speed limiter part of the function, the old "current->nice = " lines were deleted.

After a few more search (and looking through LXR) at /fs/jffs2/background.c and /net/bluetooth/bnep/core.c I've realized that some people have changed "current->nice =" statements to "set_user_nice(current,...)" ones.

Done that. The RAID worked just fine (still resyncing at boot, not fully tested yet) but don't block mounts anymore (btw, mount returns a lot faster than with 2.4.23).

Since I'm no kernel (nor RAID) expert (first post here, btw), just wandering if I did something really stupid or not.

Also, is this an Alpha-only issue? Or a 2.6.0 issue?

Anyway, here follows the patch for what I've done.

thanks for the attention.

Fernando Serboncini

drivers/md/md.c 2003-12-10 23:29:33.000000000 -0200 renamed from drivers/md/md.c 2003-11-26 18:43:29.000000000 -0200 +0 -0
@@ -3290,6 +3290,8 @@
                currspeed = 

(j-mddev->resync_mark_cnt)/2/((jiffies-mddev->resync_mark)/HZ +1) +1;

                if (currspeed > sysctl_speed_limit_min) {
+                       set_user_nice(current,19);
+
                        if ((currspeed > sysctl_speed_limit_max) ||
                                        !is_mddev_idle(mddev)) {
                                current->state = TASK_INTERRUPTIBLE;
@@ -3297,6 +3299,8 @@
                                goto repeat;
                        }
                }
+               else
+                       set_user_nice(current,-20);
        }
        printk(KERN_INFO "md: md%d: sync done.\n",mdidx(mddev));
        /*