RTL8139
Subsystems (2)
Hello readers:
I purchased a couple of encore ENL832-tx NIC's that Linux doesn't recognize.
they are based on RTL8139C (06117S1)
The module 8139too (2.4.23) doesn't load. It behaves as though no recognized hardware exists.
Any comments?
Leo
Quoted 2 lines · Leo Cambilargiu
The module 8139too (2.4.23) doesn't load. It behaves as though no recognized hardware exists.
Normally the module will load fine even with no supported hardware. At least PCI drivers tend to work that way.
Quoted 1 line
Any comments?
Show us the errors you get when you try to load the module. In case the module does load fine but doesn't recognise your board, send us the output of "lspci -vvv" (as root).
Signature · 2 lines
Regards, Rask Ingemann Lambertsen
Quoted 9 lines · Leo Cambilargiu
Hello readers:
I purchased a couple of encore ENL832-tx NIC's that Linux doesn't recognize.
they are based on RTL8139C (06117S1)
The module 8139too (2.4.23) doesn't load. It behaves as though no recognized hardware exists.
Any comments?
Probably you need to add PCI ids to 8139too.c...
Hi,
When i am trying to download the manual of 8139C from realtek site, I am getting 8139C(L) manual. And as per that the device id should be 8129 for 8139C(L).
So there is a possibility that if you enable the CONFIG_8139TOO_8129 you might get the card working.
Leo,
Have you enabled
"Support for older RTL-8129/8130 boards" option in the make menuconfig(that will enable the
CONFIG_8139TOO_8129 )? If not then can you enable
it and try out ?
Regards,
KK.
Quoted 18 lines · Jeff Garzik
Quoted 11 lines · Leo Cambilargiu
Hello readers:
I purchased a couple of encore ENL832-tx NIC's that Linux doesn't recognize.
they are based on RTL8139C (06117S1)
The module 8139too (2.4.23) doesn't load. It behaves as though no recognized hardware exists.
Any comments?
Probably you need to add PCI ids to
8139too.c...