e1000 in 2.6.1-mm1 -- still broken?
I'm having trouble with e1000 in -mm1. (works in 2.6.1) The device is detected and shows up and can be configured, but nothing ever goes out on the wire.
Here is the device info:
07:01.1 Ethernet controller: Intel Corporation: Unknown device 1010 (rev 01)
Subsystem: Intel Corporation: Unknown device 1011
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 49 Memory at fe9e0000 (64-bit, non-prefetchable) [size=128K] I/O ports at dc00 [size=64]
Capabilities: [dc] Power Management version 2
Capabilities: [e4] PCI-X non-bridge device.
Capabilities: [f0] Message Signalled Interrupts: 64bit+ Queue=0/0
Enable-
tcpdump shows no activity when I attempt to use the e1000 interface.
Quoted 4 lines · Eric Whiting
I'm having trouble with e1000 in -mm1. (works in 2.6.1) The device is detected and shows up and can be configured, but nothing ever goes out on the wire.
Hum, OK. We'd better Cc the maintainers.
Quoted 15 lines
Here is the device info:
07:01.1 Ethernet controller: Intel Corporation: Unknown device 1010 (rev 01)
Subsystem: Intel Corporation: Unknown device 1011
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 49 Memory atfe9e0000(64-bit, non-prefetchable) [size=128K] I/O ports at dc00 [size=64]
Capabilities: [dc] Power Management version 2
Capabilities: [e4] PCI-X non-bridge device.
Capabilities: [f0] Message Signalled Interrupts: 64bit+ Queue=0/0
Enable-tcpdump shows no activity when I attempt to use the e1000 interface.
Quoted 2 lines · Eric Whiting
I'm having trouble with e1000 in -mm1. (works in 2.6.1) The device is detected and shows up and can be configured, but nothing ever goes out on the wire.
Should be fixed when akpm updates the e1000 patch to
http://www.kernel.org/pub/linux/kernel/people/jgarzik/patchkits/2.6/2.6.1-netdrvr-exp1.patch.bz2
http://www.kernel.org/pub/linux/kernel/people/jgarzik/patchkits/2.6/2.6.1-netdrvr-exp1.log