Skip to contentSkip to conversation

EXT2-FS Error (ext2_new_block) Where is this comming from?? can anyone help

DISCUSSION Nauman 2 participants 3 messages May 5, 2005 – May 13, 2005

lore
Share & tools
lore

Nauman

author
#0 lore raw

Dear linux gurus,
I have set up a Block Device over a SCSI drive. I write data to the actual target drive after writing same blocks in my RAMDISK. I am using RAMDISK of 2 GB. once the allcoated blocks of my RAMDISK are full i start freeing those blocks (WRITE THROUGH). at this point i get this message during Write operations
Ext2 FS- Error: ext2_new_block : Allocating blocks in System zone. <block_nr> Is this some sort of calculation error or some other configuration problem??

Signature · 3 lines
When the going gets tough, The tough gets going...!
Peace ,  
Nauman.
#1 lore raw

Hello,

Quoted 7 lines

I have set up a Block Device over a SCSI drive. I write data to the actual target drive after writing same blocks in my RAMDISK. I am using RAMDISK of 2 GB. once the allcoated blocks of my RAMDISK are full i start freeing those blocks (WRITE THROUGH). at this point i get this message during Write operations
Ext2 FS- Error: ext2_new_block : Allocating blocks in System zone. <block_nr> Is this some sort of calculation error or some other configuration problem??

This message means that ext2_new_block() got somehow tricked to
allocate a block in the place where inode tables, bitmaps or superblocks are. I.e. the filesystem is probably corrupted. It's hard to tell how that happened - you use some standard tools to create the above described setup or it's just your own kernel hack?

Honza

Signature · 2 lines
Jan Kara <[email protected]>
SuSE CR Labs
author
#2 lore raw
In reply to Nauman

thanks for ur reply Honza ,
that problem was solved .. that was my own kernel hack. and was due to some calculation bugs
:)
Nauman

Quoted 14 lines · Nauman

Dear linux gurus,
I have set up a Block Device over a SCSI drive. I write data to the actual target drive after writing same blocks in my RAMDISK. I am using RAMDISK of 2 GB. once the allcoated blocks of my RAMDISK are full i start freeing those blocks (WRITE THROUGH). at this point i get this message during Write operations
Ext2 FS- Error: ext2_new_block : Allocating blocks in System zone. <block_nr> Is this some sort of calculation error or some other configuration problem??

--
When the going gets tough, The tough gets going...! Peace ,
Nauman.

Signature · 3 lines
When the going gets tough, The tough gets going...!
Peace ,  
Nauman.