Skip to contentSkip to conversation

NinjaSCSI PCMCIA card

DISCUSSION Pavel Fedin 3 participants 3 messages Sep 26, 2007

lore
Share & tools
lore
#0 lore raw

Hello!

Can i get this card working? Hotplug doesn't recognise it, however i
know that Linux supports it. My kernel is relatively new (2.6.11.1). cartctl info gives this:
--- cut ---
PRODID_1=" "
PRODID_2="NinjaSCSI Card_"
PRODID_3="Ver 1.00"
PRODID_4="NS00100M"
MANFID=0000,0000
FUNCID=255
--- cut ---
I wonder why the hell does it have empty numeric IDs?

Signature · 2 lines
Best regards,
 Pavel                          mailto:[email protected]
#1 lore raw
Quoted 4 lines · On Wed, 26 Sep 2007 11:39:12 +0400 Pavel Fedin <[email protected]> wrote:

Hello!

Can i get this card working? Hotplug doesn't recognise it, however i
know that Linux supports it.

The kernel supports the NinjaSCSI-3 and UltraNinja-16 (you couldn't make these names up could you) but not afaik the card you have a dump of there

#2 lore raw
Quoted 7 lines · Alan Cox
Quoted 4 lines

Hello!

Can i get this card working? Hotplug doesn't recognise it, however i
know that Linux supports it.

The kernel supports the NinjaSCSI-3 and UltraNinja-16 (you couldn't make these names up could you) but not afaik the card you have a dump of there

And don't forget NinjaATA...