Skip to contentSkip to conversation

I can get u-boot working on my ixp425 board.

U-Boot-Users Bernieshu 2 participants 2 messages Feb 20, 2004

lore
Share & tools
lore
#1 lore raw
In reply to Bernieshu
Quoted 3 lines · In message <[email protected]> you wrote:

I got the u-boot-1.0.0. And make clean, make ixdp425_config , and make. The 1st first time there is a "Soft FP" issue. After I changed

Then your cross toolchain is misconfigured / inadequate for this job.

Quoted 3 lines

cpu/ixp/config.mk as following

" PLATFORM_RELFLAGS += -mhard-float #Change -msoft-float to -mhard-float"

Don;t do this!!!

Quoted 2 lines

u-boot.bin onhand, that one can work). What could be the problem in the configuration or something else?

Make sure to use a toolchain that supports soft-float.

Best regards,

Wolfgang Denk

Signature · 3 lines
See us @ Embedded World, Nuremberg, Feb 17 - 19,  Hall 12.0 Booth 440
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Hindsight is an exact science.

Bernieshu

author
#0 lore raw

Hi, all,

I am trying to use u-boot on my ixp425 based board. But it seems not working properly.

I got the u-boot-1.0.0. And make clean, make ixdp425_config , and make. The 1st first time there is a "Soft FP" issue. After I changed cpu/ixp/config.mk as following

" PLATFORM_RELFLAGS += -mhard-float #Change -msoft-float to -mhard-float"

The compile was OK and I got u-boot.bin. But after I burn into flash, I can see nothing from serial port. I am sure my serial port works fine and burn into flash correctly (because I have another pre-compiled u-boot.bin onhand, that one can work). What could be the problem in the configuration or something else?

Regards & Thanks