Re: [Re: Logging packets with original address]
Hi
I can have the log in the PREROUTING chain. But, I have to log
ACCEPTed
and DROPped packets in the INPUT / FORWARD chains separately. I use the options in the LOG target to tag the ACCEPTed and DROPped packets.
So, I cannot have them logged in the PREROUTING chain, where we will not know
whether the packet is going to be accepted or dropped.
I have to log the messages in the INPUT or FORWARD chains, but with
the
original addresses.
Regards
Prabha
From [email protected] Wed Mar 3 09:53:24 2004
Quoted 11 lines
From: [email protected] (Antony Stone)
Date: Wed, 3 Mar 2004 09:53:24 +0000
Subject: Logging packets with original address
In-Reply-To: <[email protected]>
References: <[email protected]>
Message-ID: <[email protected]>On Wednesday 03 March 2004 9:10 am, prabha wrote:
Hi
I want to log some packets in the INPUT and FORWARD chains, but
with
Quoted 6 lines
the original address of the packets. (ie) with the destination address
before any DNAT rule has been applied on the packet in the PREROUTING chain.
You cannot do this because packets pass through the INPUT chain after
they
Quoted 8 lines
pass through PREROUTING.
When the packet comes to the INPUT / FORWARD chains, it will be
after any DNAT has been applied.Correct.
I do not want the NATted address to be present in the logs, but the
original
Quoted 7 lines
address as the received interface saw it. Is this possible?
Put the LOG rule in the PREROUTING chain.
Regards,
Antony.