Skip to contentSkip to conversation

NVIDIA and 2.6.4?

DISCUSSION Sid Boyce 1 participant 2 messages Mar 14, 2004

lore
Share & tools
lore

Sid Boyce

author
#0 lore raw
Quoted 8 lines · Adam Jones
Quoted 4 lines · Sid Boyce

/ Max Valdez wrote:/

/ >Been using nvidia modules for quite a few 2.6.x kernels, most of them mmX. / / >without problems/

I'm using it here with 2.6.4, no problems as yet.

Quoted 7 lines
Quoted 3 lines

/ Something strange happened, I shall try 2.6.4-mm1 shortly to see if it / / is still the same. I reckon though that I've suffered a filesystem / / corruption./

A quick thought - have you got CONFIG_REGPARM enabled in the kernel config? If so, disable it and try again. (It's almost certain to cause crashes with binary modules.)

I haven't had CONFIG_REGPARM set in any of the kernels. 2.6.4-rc2-mm1 was fine until after I first booted 2.6.4-mm1, then neither would work with nvidia. I also got some strange stuff happening, including checksum errors on the driver and I had to download it again from nvidia.com on two occasions, the first redownload reinstalled once, then chksum errors, the second redownload did the same as well as chksum segfaulting, since then it's been fine. See also the garbage I get out of vi in an earlier posting. Regards
Sid.

Signature · 2 lines
Sid Boyce .... Hamradio G3VBV and keen Flyer
Linux Only Shop.
author
#1 lore raw
Quoted 15 lines · Sid Boyce
Quoted 4 lines · Adam Jones
Quoted 3 lines · Sid Boyce

/ Max Valdez wrote:/

/ >Been using nvidia modules for quite a few 2.6.x kernels, most of

them mmX. /

Quoted 5 lines
Quoted 1 line

/ >without problems/

I'm using it here with 2.6.4, no problems as yet.

Quoted 1 line

/ Something strange happened, I shall try 2.6.4-mm1 shortly to see

if it /

Quoted 2 lines
Quoted 2 lines

/ is still the same. I reckon though that I've suffered a filesystem / / corruption./

Quoted 7 lines
Quoted 3 lines

A quick thought - have you got CONFIG_REGPARM enabled in the kernel config? If so, disable it and try again. (It's almost certain to cause crashes with binary modules.)

I haven't had CONFIG_REGPARM set in any of the kernels. 2.6.4-rc2-mm1 was fine until after I first booted 2.6.4-mm1, then neither would work with nvidia. I also got some strange stuff happening, including checksum errors on the driver and I had to download it again from nvidia.com on two occasions, the first redownload reinstalled once, then chksum errors, the second redownload did the same as well as chksum segfaulting, since then it's been fine. See also the garbage I get out of vi in an earlier posting. Regards
Sid.

*** CORRECTION *** 2.6.4-rc2-mm1 is the one that caused the trouble as stated in the first post. I'm yet to boot up 2.6.4-mm1. Some of the files in lost+found seem to be kde settings which I noticed were missing and had to setup again. Regards
Sid.

Signature · 2 lines
Sid Boyce .... Hamradio G3VBV and keen Flyer
Linux Only Shop.