Skip to contentSkip to conversation

Need help about scanner (2.6.2-mm1)

DISCUSSION Sid Boyce 1 participant 1 message Mar 18, 2004

lore
Share & tools
lore

Sid Boyce

author
#0 lore raw
Quoted 11 lines · Azog

Thank you so much for the tip! This seems to have solved my problem too.

I changed my epson.conf file to just say
"usb"
instead of
"usb /dev/usb/scanner0"

and now, finally, it works. I do hope the SANE documentation writers get around to adding that little tidbit of info SOMEWHERE, I was tearing my hair out and rebooting back to 2.4 to use my scanner.

I tried that in 2.6.5-rc1-mm1, restarted sane, but it still fails. scanimage -L does not find the scanner, sane-find-scanner finds it, but says I have scsi modules loaded, even though I've rmmod them. I'm using a recent CVS libusb and sane.
I found an article on linuxtoday.com that pointed me to vuescan where I downloaded their initial linux release and the scanner (Epson USB 610) works fine using it. It uses the libusb-0.1.so.4.4.1 I have installed, so that points back to a problem with sane which I have added to their bug list. Regards
Sid.

Signature · 2 lines
Sid Boyce .... Hamradio G3VBV and keen Flyer
Linux Only Shop.